Reinforcement layout design of RC structures under multiple load cases using truss-like material model
Open Access
- 1 January 2020
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 17 (4)
Abstract
This paper proposes a method to optimize the reinforcement layout of RC structures under multiple load cases (MLCs) using the planar truss-like material model. It is assumed that concrete is filled with truss-like materials. Two families of orthotropic members in the truss-like materials are used to simulate steel bars. The densities and orientations of steel bars at nodes are considered as design variables. The optimization problem is to minimize the total volume of steel bars with stress constraints. First, under each load case, the distribution of steel bars is optimized as per the fully stressed criterion. Second, based on the results obtained above, the directional stiffness of steel bars under MLCs, described by a closed quadratic curve, is determined using the least squares method. Finally, by solving the eigenvalues problem of the coefficient matrix of the quadratic curve, the optimal distribution of steel bars under MLCs is obtained.Keywords
This publication has 16 references indexed in Scilit:
- A numerical method to generate optimal load paths in plain and reinforced concrete structuresComputers & Structures, 2016
- Topology optimization of reinforced concrete structures considering control of shrinkage and strength failureComputers & Structures, 2015
- Doing Topology Optimization Explicitly and Geometrically—A New Moving Morphable Components Based FrameworkJournal of Applied Mechanics, 2014
- Reinforcement layout design for concrete structures based on continuum damage and truss topology optimizationStructural and Multidisciplinary Optimization, 2012
- Layout design of reinforced concrete structures using two-material topology optimization with Drucker–Prager yield constraintsStructural and Multidisciplinary Optimization, 2012
- Generating strut-and-tie patterns for reinforced concrete structures using topology optimizationComputers & Structures, 2009
- Determination of strut-and-tie models using evolutionary structural optimizationEngineering Structures, 2006
- Strut-and-Tie Design Methodology for Three-Dimensional Reinforced Concrete StructuresJournal of Structural Engineering, 2006
- Optimal shape design as a material distribution problemStructural and Multidisciplinary Optimization, 1989
- Generating optimal topologies in structural design using a homogenization methodComputer Methods in Applied Mechanics and Engineering, 1988