XRD and UV–Vis studies of cellulose acetate film blended with different concentrations of nano-metal oxide
Authors:
Open Access
- 30 March 2024
- journal article
- research article
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (5) , 1-21
Abstract
Molybdenum Trioxide nanoparticle (MoO3-NPs) was introduced to Cellulose acetate (CA) biopolymer with different concentration using casting process by dispersed MoO3-NPs [0.0, 0.25, 0.5 and 1.0 wt%]. Molecular structure of samples has been studied using XRD and UV–Vis. the data shown by X-ray results indicated the amorphous nature of the pure polymer. Some peaks are appeared as a result of the addition of MoO3-NPs which indicate that samples were partially crystallized. The crystallite size of nano-metal oxide was calculated for blended samples by Size–Strain Plot method which was found to increase with increasing the concentration of MoO3. UV–Vis results indicate that there exist two indirect energy band gaps; Onset band gap which observed to decreases from 1.3 eV for pure polymer to 0.78 eV for polymer blended with 1.0 wt% MoO3-NPs and HOMO–LOMO band gap which observed to decrease from 3.23 eV for pure polymer to 2.89 eV for polymer blended with 1.0 wt% MoO3-NPs. This indicate that the addition of nano-metal oxide improve the optical conduction of CA. Urbach energy was observed to increase with increasing MoO3-NPs from 0.27 eV for pure CA to 0.32 eV for 1.0 wt% MoO3-NPs concentration which may be occurred due to the creation localized states at the band gap as a result of the addition of MoO3-Nps.Keywords
Funding Information
- Obour Higher Institute for Management and Information Technology
This publication has 60 references indexed in Scilit:
- Bromophenol blue doped in nano-droplet: spectroscopy, nonlinear optical properties and Staphylococcus aureus treatmentOptical and Quantum Electronics, 2020
- Spectroscopic studies, molecular structure optimization and investigation of structural and electrical properties of novel and biodegradable Chitosan-GO polymer nanocompositesJournal of Materials Science, 2020
- Optical cellulose fiber made from regenerated cellulose and cellulose acetate for water sensor applicationsCellulose, 2019
- Investigating the structural and optical properties of thermally evaporated 1,3,3-trimethylindolino-β-naphthopyrylospiran thin filmsApplied Physics A, 2017
- Silver‐Doped Zinc Oxide as a Nanofiller for Development of Poly(vinyl alcohol)/Poly(vinyl pyrrolidone) Blend NanocompositesAdvances in Polymer Technology, 2016
- Investigation of Microstructure, Morphology, Mechanical, and Dielectric Properties of PVA/PbO NanocompositesAdvances in Polymer Technology, 2015
- Toward Printed Integrated Circuits based on Unipolar or Ambipolar Polymer SemiconductorsAdvanced Materials, 2013
- Gamma-ray irradiation induced structural and optical constants changes of thermally evaporated neutral red thin filmsJournal of Materials Science, 2011
- Influence of the substitution degrees on the optical properties of cellulose acetatesJournal of Applied Polymer Science, 2009
- X-ray diffraction and infrared spectroscopy studies on crystal and lamellar structure and cho hydrogen bonding of biodegradable poly(hydroxyalkanoate)Macromolecular Research, 2006