Thermoanalytical and dilatometric studies of the Al2O3–Cu–Mo hybrid composite
Open Access
- 2 April 2020
- journal article
- research article
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 142 (1) , 51-62
Abstract
The present research is focused on the characterization of the composites from Al2O3–Cu–Mo system. The composites were prepared by slip casting method and subsequent sintering of green bodies in a reduced atmosphere. Two series of samples with different volume content of metallic powders were produced in the work: 10 vol% and 15 vol% of metal content with respect to the total solid-phase content. The sintering process of the composites was analyzed in detail. The linear shrinkage of the composites was measured. The shrinkage curves were obtained by dilatometry test in a heating mode. The composites were characterized by DTA/TG analyses and thermal conductivity. The composites were characterized by XRD, SEM, and EDX. The hardness was measured by Vickers hardness tester. Moreover, the Brazilian test was performed to determine the tensile mechanical properties of the composites. Fractography investigation was carried out as well. Dilatometric tests showed that the increase of the metallic phase volume in the ceramic matrix causes a decrease in the starting temperature of densification. Simultaneously, dilatometric experiments indicated that an increasing amount of metallic particles into the ceramic matrix increases the temperature of maximum densification and decreases the total shrinkage of the composites during sintering. The DTA/TG showed the characteristics of the dispersant decomposition to the atmosphere during thermal treatment and increase of mass connected with the oxidation of metals. Fractography results revealed good adhesion between Al2O3 matrix and the metallic phase. The observation allowed to conclude that the Al2O3 matrix surface is characterized by the brittle fracture mechanism.Keywords
Funding Information
- Narodowe Centrum Nauki (OPUS 13’ no. UMO-2017/25/B/ST8/02036)
- Fundacja na rzecz Nauki Polskiej (START)
This publication has 25 references indexed in Scilit:
- Properties of Water-Based Slurries for Fabrication of Ceramic-Metal Composites by Slip Casting MethodArchives of Metallurgy and Materials, 2011
- Study of polycrystalline Al2O3 machining cracks using discrete element methodInternational Journal of Machine Tools and Manufacture, 2008
- Numerical investigation on the dynamic behavior of advanced ceramicsEngineering Fracture Mechanics, 2004
- Optimization of the rheological properties of alumina slurries for ceramic processing applications Part II: Spray-dryingJournal of the European Ceramic Society, 2001
- Microstructure and mechanical properties of alumina/copper composites fabricated by different infiltration techniquesMaterials Letters, 1998
- Fabrication and mechanical properties of 5 vol% copper dispersed alumina nanocompositeJournal of the European Ceramic Society, 1998
- Fracture energy and R-curve behavior of Al2O3/Mo compositesActa Materialia, 1998
- Composite Titanium dental implant fabricated by electro-discharge compactionBiomaterials, 1997
- Aluminium nitride-molybdenum ceramic matrix composites. Influence of molybdenum addition on electrical, mechanical and thermal propertiesJournal of the European Ceramic Society, 1997
- Fabrication and mechanical behaviour of Al2O3/Mo nanocompositesJournal of Materials Science, 1994