Research on Key Factors of Sealing Performance of Combined Sealing Ring
Open Access
- 12 January 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (2) , 714
Abstract
In this study, the mechanical properties of a combined seal ring under different loads were numerically calculated using ANSYS. The effect of the working pressure and pre-compression ratio of a rubber O-ring on the contact stress of the combined seal ring was studied. The influence of the wear ring’s chamfer, thickness, and width on the contact stress and contact force of the combined seal ring was analyzed. Studies have shown that it is particularly important to select a compression ratio that is suitable for the working conditions. Under the same conditions of working pressure and compression ratio, upon increasing the wear ring chamfer, the contact pressure is decreased due to the decreasing contact bandwidth between the wear ring and the cylinder wall. This has little effect on the contact stress of the combined seal ring as well as the contact force, while the width of the wear ring is proportional to the latter.Keywords
This publication has 17 references indexed in Scilit:
- Tribological and Sealing Performance of Laser Pocketed Piston Rings in a Diesel EngineTribology Letters, 2016
- Friction of hydraulic rod seals at high velocitiesTribology International, 2015
- A hydraulic cylinder model for multibody simulationsComputers & Structures, 2014
- Improving tribological behaviour of piston ring–cylinder liner frictional pair by liner surface texturingTribology International, 2013
- Study on Influence of Cylinder Liner Surface Texture on Lubrication Performance for Cylinder Liner–Piston Ring ComponentsTribology Letters, 2013
- The effect of groove texture patterns on piston-ring pack frictionPrecision Engineering, 2012
- Modeling of dynamic friction behaviors of hydraulic cylindersMechatronics, 2012
- Friction and wear studies between cylinder liner and piston ring pair using Taguchi design methodAdvances in Engineering Software, 2011
- Experimental friction evaluation of cylinder liner/piston ring contactWear, 2011
- Frictional Behavior of Steel-PTFE Interfaces for Seismic IsolationBulletin of Earthquake Engineering, 2005