Effects of Different Cutting Processes on Characteristics of Cut Damage for the Third‐Generation Automobile Medium‐Mn Steel
Authors:
- 20 November 2017
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 89 (9)
Abstract
The third‐generation automobile medium‐Mn (TAMM) steel containing large‐fractioned metastable austenite is cut by three cutting processes, such as shearing, laser‐cutting, and wire‐cut electrical discharge machining (WEDM). Microstructure, microhardness, and tensile properties are discussed to analyze the effect of cutting process on cut damage. The results show that the TAMM samples treated by three cutting processes present different microstructures. Firstly, microvoids are elongated by plastic deformation and martensite is generated due to TRIP effect for sheared edge, which decreases formability and become potential cracking reasons. Secondly, martensitic transformation is found for laser‐cut edge due to temperature variation during laser‐cutting, according to continuous cooling transformation (CCT) curve of TAMM steel. Thirdly, no martensite and elongated microvoids occur during WEDM. The WEDM edge keeps original microstructures. Furthermore, microhardness of sheared edge and laser‐cut edge sub‐surface is increased. Shear‐affected zone is about 1755 µm and laser‐cut‐affected zone is about 250 µm. However, microhardness is nearly not influenced by WEDM process. Besides, tensile displacement is affected obviously by cutting process. The stretchability of WEDM sample is the best. Tensile properties of sheared sample can be improved by adjusting die clearance. This paper is favorable to select cutting process and improve manufacturing ability of TAMM steel.Keywords
Funding Information
- National Natural Science Foundation of China (51571048, 51405060)
- China Postdoctoral Science Foundation (2016M591425)
- Natural Science Foundation of Liaoning Province (2014028001)
This publication has 16 references indexed in Scilit:
- Edge crack sensitivity of lightweight materials under different load conditionsIOP Conference Series: Materials Science and Engineering, 2016
- Investigation on Shearing and Local Formability of Hot-Rolled High-Strength PlatesJournal of Manufacturing Science and Engineering, 2016
- Experimental and numerical analysis of influence of carbide on austenitisation kinetics in 5Mn TRIP steelMaterials Science and Technology, 2014
- Experiments and modeling of edge fracture for an AHSS sheetInternational Journal of Fracture, 2014
- Analysis of deformation behavior and workability of advanced 9Cr–Nb–V ferritic heat resistant steelsMaterials Science and Engineering: A, 2014
- An investigation of mechanical property and three-body impact abrasive wear behavior of a 0.27% C dual phase steelMaterials & Design (1980-2015), 2013
- Failure during Sheared Edge Stretching of Dual-Phase SteelsMetallurgical and Materials Transactions A, 2013
- Die design for a center pillar part by process analysis of hot stamping and its experimental verificationInternational Journal of Precision Engineering and Manufacturing, 2012
- Characterization of mechanically sheared edges of dual phase steelsJournal of Materials Processing Technology, 2012
- Review of the Shearing Process for Sheet Steels and Its Effect on Sheared-Edge StretchingJournal of Materials Engineering and Performance, 2011