Digital control of a single-phase boost rectifier with power factor correction using a dsPIC
Authors:
- 1 November 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Abstract
A digital implementation of a boost rectifier with power factor correction (PFC) is presented. The proposed control involves a current control loop and a voltage control loop. The current control loop is implemented with two different methods: (a) linear compensation; and (b) ON-OFF control. The voltage control loop is implemented with a proportional-integral (PI) controller. Several Simulink/MATLAB simulations of the converter operating with both current control methods are presented. An assessment of the total harmonic distortion (THD) measurements shows the advantages of the simple ON-OFF controller. Finally, experimental results obtained from a 100W prototype using a low-cost 16-bit microcontroller are included and discussed.Keywords
This publication has 5 references indexed in Scilit:
- Predictive current control in a single phase PFC boost rectifier2009
- General control for boost PFC converter from a sliding mode viewpoint2008
- Digitally Controlled Boost PFC Converter with Improved Output Voltage ControllerElectrical Engineering, 2006
- DSP implementation of a single-cycle predictive current controller in a boost PFC rectifier2005
- Nonlinear-carrier control for high-power-factor boost rectifiersIEEE Transactions on Power Electronics, 1996