Molecular Order in High-Efficiency Polymer/Fullerene Bulk Heterojunction Solar Cells
- 6 October 2011
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 5 (10) , 8248-8257
Abstract
We report quantitative measurements of ordering, molecular orientation, and nanoscale morphology in the active layer of bulk heterojunction (BHJ) organic photovoltaic cells based on a thieno[3,4-b]thiophene-alt-benzodithiophene copolymer (PTB7), which has been shown to yield very high power conversion efficiency when blended with [6,6]-phenyl-C71-butyric acid methyl ester (PC71BM). A surprisingly low degree of order was found in the polymer—far lower in the bulk heterojunction than in pure PTB7. X-ray diffraction data yielded a nearly full orientation distribution for the polymer π-stacking direction within well-ordered regions, revealing a moderate preference for π-stacking in the vertical direction (“face-on”). By combining molecular orientation information from polarizing absorption spectroscopies with the orientation distribution of ordered material from diffraction, we propose a model describing the PTB7 molecular orientation distribution (ordered and disordered), with the fraction of ordered polymer as a model parameter. This model shows that only a small fraction (≈20%) of the polymer in the PTB7/PC71BM blend is ordered. Energy-filtered transmission electron microscopy shows that the morphology of PTB7/PC71BM is composed of nanoscale fullerene-rich aggregates separated by polymer-rich regions. The addition of diiodooctane (DIO) to the casting solvent, as a processing additive, results in smaller domains and a more finely interpenetrating BHJ morphology, relative to blend films cast without DIO.Keywords
This publication has 44 references indexed in Scilit:
- Correlating the scattered intensities of P3HT and PCBM to the current densities of polymer solar cellsChemical Communications, 2010
- Improved Film Morphology Reduces Charge Carrier Recombination into the Triplet Excited State in a Small Bandgap Polymer‐Fullerene Photovoltaic CellAdvanced Materials, 2010
- A Thermally Stable Semiconducting PolymerAdvanced Materials, 2010
- Scherrer grain-size analysis adapted to grazing-incidence scattering with area detectorsJournal of Applied Crystallography, 2009
- Substrate-dependent interface composition and charge transport in films for organic photovoltaicsApplied Physics Letters, 2009
- Determining exciton bandwidth and film microstructure in polythiophene films using linear absorption spectroscopyApplied Physics Letters, 2009
- Transition from Solution to the Solid State in Polymer Solar Cells Cast from Mixed SolventsMacromolecules, 2008
- Automated Analysis of SEM X-Ray Spectral Images: A Powerful New Microanalysis ToolMicroscopy and Microanalysis, 2003
- Measurement of the Anisotropic Refractive Indices of Spin Cast Thin Poly(2-methoxy-5-(2′-ethyl-hexyloxy)-p-phenylenevinylene) (MEH-PPV) FilmsAdvanced Materials, 2002
- Computer Visualization of Three-Dimensional Image Data Using IMODJournal of Structural Biology, 1996