Abstract
The traditional polysilicon processes should be refined when addressing the low energy consumption requirement for the produc- tion of solar grade silicon. This paper addresses the fluid dynamic conditions required to deposit polysilicon in the traditional Siemens reactor. Analytical solutions for the deposition process are presented, providing information on maximizing the rate between the amount of polysilicon obtained and the energy consumed during the deposition process. The growth rate, deposition efficiency, and power-loss dependence on the gas velocity, the mixture of gas composition, the reactor pressure, and the surface temperature have been analyzed. The analytical solutions have been compared to experimental data and computational solutions presented in the literature. At atmospheric pressure, the molar fraction of hydrogen at the inlet should be adjusted to the range of 0.85-0.90, the gas inlet temperature should be raised within the interval of 673 and 773 K, and the gas velocity should reach the Reynolds number 800. The resultant growth rate will be between 6 and 6.5 mm in 1 . Operation above atmospheric pressure is strongly recommended to achieve growth rates of 20 mm in 1 at 6 atm. The strong photovoltaic PV market growth relies on crystalline silicon, using highly purified silicon as raw material, which is re- ferred to as polysilicon. Traditionally, polysilicon for the solar in- dustry has been obtained from the microelectronics industry, using off-spec material or the excess capacity of polysilicon producers. But the tremendous growth of the PV industry has produced a rapid change in the situation: while in 2000, PV only demanded 10% of the polysilicon, in 2005, PV demand surpassed that of the micro- electronic industry, in the range of 15.000 t, 1 and the global demand exceeded the production capacity. Nevertheless, the silicon shortage that threatened PV industry is being overcome. This is resultant from initiatives taken by the polysilicon and the PV industry to keep on growing. Optimization of the purification process to address solar cell requirements must also be pursued in order to reduce the cost of the material as much as possible. For the moment, the consolidated route in the market to produce polysilicon is based on the synthesis and purification of silanes monosilane MS or trichlorosilane TCS, and their subsequent reduction in a chemical vapor deposi- tion CVD reactor to solid Si. Almost 77% of the polysilicon pro- duced worldwide is currently obtained from trichlorosilane in a CVD reactor known as a Siemens reactor. 2

This publication has 9 references indexed in Scilit: