Analysis of surface roughness parameters in turning of FRP tubes by PCD tool
Authors:
- K. PalanikumarK. Palanikumar
- F. MataFMF. Mata
- J. Paulo DavimJ. Paulo Davim
- 1 August 2008
- journal article
- research article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 204 (1-3) , 469-474
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- A new machinability index in turning fiber reinforced plasticsJournal of Materials Processing Technology, 2005
- Optimisation of surface roughness on turning fibre-reinforced plastics (FRPs) with diamond cutting toolsThe International Journal of Advanced Manufacturing Technology, 2004
- Influence of cutting parameters on surface roughness in turning glass‐fibre‐reinforced plastics using statistical analysisIndustrial Lubrication and Tribology, 2004
- Factors affecting the machinability of GFR/epoxy compositesComposite Structures, 2004
- Dimensional precision and surface roughness on turning tubes in fibre reinforced plastics based on the design experimentsInternational Journal of Materials and Product Technology, 2004
- An experimental investigation into the orthogonal cutting of unidirectional fibre reinforced plasticsInternational Journal of Machine Tools and Manufacture, 2003
- On the machining of fiber reinforced plastic (FRP) composite laminatesInternational Journal of Machine Tools and Manufacture, 1995
- Effect of fibre direction on surface roughness measurements of machined graphite/epoxy compositeComposites Manufacturing, 1993
- Machining of Fibre Reinforced PlasticsCIRP Annals, 1985
- Tool Wear in Cutting Glass-fiber-reinforced Plastics : The Relation between Fiber Orientation and Tool WearBulletin of JSME, 1983