Powder Process with Photoresist for Ceramic Electronic Components
Authors:
- Minami KanekoMKMinami Kaneko
- Ken SaitoKSKen Saito
- Fumio UchikobaFUFumio Uchikoba
Open Access
- 26 September 2018
- book chapter
- Published by IntechOpen
Abstract
This chapter proposed a patterning process for ceramic electronic components. The proposed process uses a photoresist, and it is combined with the photolithography process and the printing process. By using both technologies, a high-aspect-ratio and fine conductive pattern is achieved because the patterned photoresist hold the filling paste during the dry process. Moreover, a different material pattern in a ceramic sheet can be formed simultaneously when the photoresist covers on the ceramic sheet with a through-hole pattern. The examples of the patterning process and the fabricated pattern are shown. The fine conductive pattern was formed by using a liquid photoresist, and the line width and the thickness were 10.3 and 1.85 μm, respectively. In the ceramic pattern, the conductive paste and low-temperature co-fired ceramic (LTCC) slurry were filled to the ferrite sheet. As a result, the ceramic sheet that had three different materials was achieved. It realizes the miniature ceramic inductor suppressing the minor loop. However, the photoresist process showed some problems with the fine pattern and the different material pattern. These problems are solved by adjusting the viscosity and the composite ratio of the slurry. The optimization of the type and thickness of the photoresist is required.Keywords
This publication has 8 references indexed in Scilit:
- Tape casting and characterization of Li 2.08 TiO 3 -LiF glass free LTCC for microwave applicationsJournal of the European Ceramic Society, 2017
- A compact 802.11b/g WLAN front-end module with integrated passive devices on modified ceramic substrate2009
- Characterization of Inductor with Ni–Zn–Cu Ferrite Embedded in B2O3–SiO2 GlassJapanese Journal of Applied Physics, 2007
- Co-fireable copper multilayered ceramic substrates2003
- Overview of low temperature co-fired ceramics tape technology for meso-system technology (MsST)Sensors and Actuators A: Physical, 2001
- Low Firing Temperature Multilayer Glass-Ceramic SubstrateIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1983
- Combination of Thick‐Film Dielectric/Thin Film Conductor for FinePattern Formation of Multi‐Layer SubstrateActive and Passive Electronic Components, 1981
- A Multilayer Ceramic Multichip ModuleIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1980