Comparative Evaluation of Surface Quality, Tool Wear, and Specific Cutting Energy for Wiper and Conventional Carbide Inserts in Hard Turning of AISI 4340 Alloy Steel
Open Access
- 19 November 2020
- Vol. 13 (22) , 5233
Abstract
This paper presents an experimental study into the comparative response of wiper and round-nose conventional carbide inserts coated with TiCN + AL2O3 + TiN when turning an AISI 4340 steel alloy. The optimal process parameters, as identified by pre-experiments, were used for both types of inserts to determine the machined surface quality, tool wear, and specific cutting energy for different cutting lengths. The wiper inserts provided a substantial improvement in the attainable surface quality compared with the results obtained using conventional inserts under optimal cutting conditions for the entire range of the machined lengths. In addition, the conventional inserts showed a dramatic increase in roughness with an increased length of the cut, while the wiper inserts showed only a minor increase for the same length of cut. A scanning electron microscope was used to examine the wear for both types of inserts. Conventional inserts showed higher trends for both the average and maximum flank wear with cutting length compared to the wiper inserts, except for lengths of 200–400 mm, where conventional inserts showed less average flank wear. A higher accumulation of deposited chips was observed on the flank face of the wiper inserts than the conventional inserts. The experimental results demonstrated that edge chipping was the chief tool wear mechanism on the rake face for both types of insert, with more edge chipping observed in the case of the conventional inserts than the wiper inserts, with negligible evidence of crater wear in either case. The wiper inserts were shown to have a higher specific cutting energy than those detected with conventional inserts. This was attributed to (i) the irregular nose feature of the wiper inserts differing from the simpler round nose geometry of the conventional inserts and (ii) a higher tendency of chip accumulation on the wiper inserts.Keywords
This publication has 47 references indexed in Scilit:
- Comparative assessment of wiper and conventional ceramic tools on surface roughness in hard turning AISI 4140 steelMeasurement, 2013
- Machinability investigations on hardened AISI 4340 steel using coated carbide insertInternational Journal of Refractory Metals and Hard Materials, 2012
- Experimental Study on Cryogenic Cutting of High-Strength Steel with Liquid Nitrogen CoolingAdvanced Materials Research, 2011
- Surface roughness measurement in turning carbon steel AISI 1045 using wiper insertsMeasurement, 2011
- Effect of Cutting Parameters on Minimum Quantity Lubrication Machining of High Strength SteelMaterials Science Forum, 2009
- Machinability investigations in hard turning of AISI D2 cold work tool steel with conventional and wiper ceramic insertsInternational Journal of Refractory Metals and Hard Materials, 2009
- Modelling of surface finish and tool flank wear in turning of AISI D2 steel with ceramic wiper insertsJournal of Materials Processing Technology, 2007
- Forces in hard turning of 51CrV4 with wiper cutting toolTsinghua Science and Technology, 2006
- Evaluation of machinability by cutting environments in high-speed milling of difficult-to-cut materialsJournal of Materials Processing Technology, 2001
- On Microchip Formation During Machining of a High Strength SteelJournal of Engineering Materials and Technology, 1974