Non-contact lateral force microscopy
Author:
- 17 July 2017
- journal article
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 29 (32) , 323001
Abstract
The goal of atomic force microscopy (AFM) is to measure the short-range forces that act between the tip and the surface. The signal recorded, however, includes long-range forces that are often an unwanted background. Lateral force microscopy (LFM) is a branch of AFM in which a component of force perpendicular to the surface normal is measured. If we consider the interaction between tip and sample in terms of forces, which have both direction and magnitude, then we can make a very simple yet profound observation: over a flat surface, long-range forces that do not yield topographic contrast have no lateral component. Short-range interactions, on the other hand, do. Although contact-mode is the most common LFM technique, true non-contact AFM techniques can be applied to perform LFM without the tip depressing upon the sample. Non-contact lateral force microscopy (nc-LFM) is therefore ideal to study short-range forces of interest. One of the first applications of nc-LFM was the study of non-contact friction. A similar setup is used in magnetic resonance force microscopy to detect spin flipping. More recently, nc-LFM has been used as a true microscopy technique to systems unsuitable for normal force microscopy.Keywords
This publication has 77 references indexed in Scilit:
- Atomically precise bottom-up fabrication of graphene nanoribbonsNature, 2010
- Three-dimensional imaging of short-range chemical forces with picometre resolutionNature Nanotechnology, 2009
- Noncontact lateral-force gradient measurement on Si(111)-7×7 surface with small-amplitude off-resonance atomic force microscopyJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2009
- Basic properties of dynamic force spectroscopy with the scanning force microscope in experiment and simulationUltramicroscopy, 1996
- Nanotribology: friction, wear and lubrication at the atomic scaleNature, 1995
- Frequency modulation detection using high-Q cantilevers for enhanced force microscope sensitivityJournal of Applied Physics, 1991
- Structure of the H-saturated Si(100) surfacePhysical Review Letters, 1990
- Atomic Force MicroscopePhysical Review Letters, 1986
- Surface Studies by Scanning Tunneling MicroscopyPhysical Review Letters, 1982
- Tunneling through a controllable vacuum gapApplied Physics Letters, 1982