Ozone‐Assisted photocatalytic degradation of benzene using nano‐zinc oxide impregnated granular activated carbon (ZnO–GAC) in a continuous fluidized bed reactor
- 11 October 2018
- journal article
- research article
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 38 (4)
Abstract
Benzene is one of the volatile organic compounds, exposure to which causes different complications including coughs, headache, dizziness, and even cancer. Therefore, methods are required to remove benzene from polluted air. In this study, for the first time, benzene degradation was examined using photocatalytic ozonation process in the presence of nano‐zinc oxide impregnated granular activated carbon (ZnO–GAC) in a continuous fluidized bed reactor. The experiments were performed with the aim of investigating the effect of factors including the ratio of superficial gas velocity to the minimum fluidization velocity (), initial benzene concentration, relative humidity, catalyst dosage, bed temperature, ozone dosage, and intensity of UV lamp in removing benzene from the air. The results of this study indicated that the minimum fluidization velocity (Umf) was obtained as 0.47 L/min, while benzene removal efficiency reached its maximum at = 2.5. Addition of ozone to the ZnO‐UV/GAC process enhanced the process efficiency considerably. With elevation of benzene concentration from 50 to 300 ppm, removal efficiency by UV/ZnO–GAC process declined from 84.14 to 45.12%, while with O3/ZnO–GAC/UV, it decreased from 93.8 to 68.78%. The range of the optimal humidity for benzene removal in both processes was obtained as 30–35%. With elevation of ZnO–GAC dosage from 0 to 10 mg, benzene removal efficiency increased from 42.07 to 70.24 and from 60.9 to 89.57% using UV/ZnO–GAC and O3/ZnO–GAC/UV processes, respectively. Furthermore, the efficiency of O3/ZnO–GAC was directly related to bed temperature, while UV/ZnO–GAC and UV/O3/ZnO–GAC processes were inversely related. Eventually, the removal efficiency of the processes had a direct relation with the ozone dosage and UV intensity. © 2018 American Institute of Chemical Engineers Environ Prog, 38:e13082, 2019Keywords
Funding Information
- Iran University of Medical Sciences (94‐01‐27‐25738)
This publication has 47 references indexed in Scilit:
- Low temperature removal of SO2 traces from air by MgO-loaded porous carbonsChemical Engineering Journal, 2012
- Surface modification of coconut shell based activated carbon for the improvement of hydrophobic VOC removalJournal of Hazardous Materials, 2011
- Destruction of toluene by ozone-enhanced photocatalysis: Performance and mechanismApplied Catalysis B: Environment and Energy, 2011
- Fabrication of Large‐Scale Hierarchical ZnO Hollow Spheroids for Hydrophobicity and PhotocatalysisChemistry – A European Journal, 2010
- Catalytic Ozonation of Toluene Using Zeolite and MCM-41 MaterialsEnvironmental Science & Technology, 2008
- Photocatalytic oxidation of methanol using titania-based fluidized bedsApplied Catalysis B: Environment and Energy, 2007
- Photocatalytic oxidation of low molecular weight alkanes: Observations with ZrO2–TiO2 supported thin filmsApplied Catalysis B: Environment and Energy, 2006
- Photocatalytic degradation of trace hexane in the gas phase with and without ozone addition: kinetic studyJournal of Photochemistry and Photobiology A: Chemistry, 2004
- Extension of a Two-Site transient kinetic model of TiO2 deactivation during photocatalytic oxidation of aromatics: concentration variations and catalyst regeneration studiesApplied Catalysis B: Environment and Energy, 2003
- A comparative study on decomposition of gaseous toluene by O3/UV, TiO2/UV and O3/TiO2/UVJournal of Photochemistry and Photobiology A: Chemistry, 2003