Metallic Mesh Bandpass Filters and Fabry-Perot Interferometer for the Far Infrared
Authors:
- Kiyomi SakaiKSKiyomi Sakai
- Takashi FukuiTFTakashi Fukui
- Yoshiaki TsunawakiYTYoshiaki Tsunawaki
- Hiroshi YoshinagaHYHiroshi Yoshinaga
- 1 August 1969
- journal article
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 8 (8)
Abstract
This paper describes optical properties of thin electroformed metallic meshes in detail. Since the transmittance shows the bandpass character around the wavelength near the grid constant, metal mesh can be used as a bandpass filter. The reflectance is high in the wavelength region longer than three times the grid constant and the absorptivity is very low. These optical properties are suitable for reflectors of the Fabry-Perot Interferometers (FPI's) for the far infrared. Authors fabricated two types of FPI's; flxed type and tunable type. The absorption spectra of atmospheric water vapour between 100 and 400 µ and CO gas between 350 and 650 µ were scanned with the tunable FPI. Resultant resolving power of about 20 was obtained at 250 µ. Moreover, light flux which a FPI can utilize in the limited area of the light source and the detector was discussed.Keywords
This publication has 7 references indexed in Scilit:
- Metal Mesh Interference Filters for the Far InfraredApplied Optics, 1967
- Far-infrared properties of metallic mesh and its complementary structureInfrared Physics, 1967
- Metal Mesh Filters in the Far Infrared RegionJapanese Journal of Applied Physics, 1963
- Interference Filters and Fabry-Perot Interferometers for the Far InfraredApplied Optics, 1962
- Transmission Filters in the Far-Infrared RegionJournal of the Optical Society of America, 1962
- The Luminosity of Spectrometers with Prisms, Gratings, or Fabry-Perot EtalonsJournal of the Optical Society of America, 1954
- Cone Channel Condenser Optics*Journal of the Optical Society of America, 1952