Corrosion Behavior of Ti-6Al-4V with Different Thermomechanical Treatments and Microstructures
Authors:
Top Cited Papers
- 1 June 2010
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 66 (6) , 065004-1
Abstract
The corrosion behavior of four different microstructures of Ti-6Al-4V with varying volume fractions of primary α (0, 10%~20%, 40%~50%, and ~90%) was investigated in sodium chloride (NaCl) and hydrochloric acid (HCl) solutions. The microstructure constituent morphologies and distributions were characterized with optical and scanning electron microscopy (SEM) while constituent compositions were determined with energy-dispersive x-ray (EDX) analysis. All four micro-structures exhibited spontaneous passivity in 0.9% NaCl at 37°C and active/passive transitions in 1.5 M HCl at 37°C. Very little difference in corrosion rate was observed using potentiodynamic polarization curves and weight-loss tests. However, SEM analysis of corroded surfaces indicated that the fully lamellar structure (0% primary α) exhibited the worst attack. Analysis of surfaces after 48 h immersion in 3.5 M HCl revealed that α/β phase boundaries were preferential sites for corrosion attack. Also, β phase in lamellar structures exhibited preferential dissolution in comparison to α phase. The corrosion results are discussed in terms of microstructure and constituent composition. In particular, the extent of partitioning of vanadium to the β phase during heat treatment varies with the volume fractions of primary α and transform β, which affects the corrosion performance in aggressive environments.Keywords
This publication has 30 references indexed in Scilit:
- Influence of sharp microstructural gradients on the fatigue crack growth resistance of α+β and near‐α titanium alloysFatigue & Fracture of Engineering Materials & Structures, 2005
- Effect of heat treatment and silicon addition on the microstructure development of Ti–6Al–2Cr–2Mo–2Sn–2Zr alloyMaterials Science and Engineering: A, 2003
- Microstructure control by thermomechanical processing in β-Ti–15–3 alloyJournal of Materials Processing Technology, 2001
- An assessment of the instability of Ti and its alloys in acidic environments at elevated temperatureJournal of Light Metals, 2001
- Influence of Niobium and Zirconium Alloying Additions on the Anodic Dissolution Behavior of Activated Titanium in HCl SolutionsJournal of the Electrochemical Society, 2001
- Corrosion and Passivity of Ti-13% Nb-13% Zr in Comparison to Other Biomedical Implant AlloysCorrosion, 1997
- Corrosion rate of titanium in H2SO4Materials Chemistry and Physics, 1997
- The state of the USA titanium industry in 1995Materials Science and Engineering: A, 1996
- Microstructure development in a thermomechanically processed Ti15V3Cr3Sn3Al alloyMaterials Science and Engineering: A, 1996
- The electrochemical and corrosion behaviour of titanium and its alloy (VT-9) in phosphoric acidCorrosion Science, 1993