27.2 an oversampling SAR ADC with DAC mismatch error shaping achieving 105dB SFDR and 101dB SNDR over 1kHz BW in 55nm CMOS
Authors:
- 1 January 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 458-459
Abstract
The successive-approximation-register (SAR) architecture is well-known for its high power efficiency in medium-resolution A/D conversions. Together with time interleaving, it can challenge the regime of flash ADCs in high-speed, low-resolution applications [1]. However, when considered for high-precision, low-speed sensor readout interfaces, SAR ADCs suffer from nonlinearity resulting from capacitor mismatch and limited dynamic range due to comparator noise. Previous works [2-3] adopt oversampling to shift noise and nonlinearity into high frequencies. Dithering and chopping are used in [2] to modulate harmonic distortion and flicker noise out of signal bandwidth, achieving an in-band SFDR of 87.1dB and an SNDR of 79.1dB along with data-driven noise reduction. Noise shaping proposed in [3] suppresses the in-band noise around 10dB at a low oversampling ratio (OSR) of 4 with no linearity improvement. DAC nonlinearity can also be calibrated digitally, but to achieve an INL down to ±2ppm [4], calibration of capacitor 2nd-order voltage coefficients is required. This work presents a DAC mismatch error shaping (MES) scheme for oversampling SAR ADCs to achieve a 105dB in-band SFDR without calibration. The DAC mismatch errors are 1st-order high-pass filtered by simply inserting one extra phase into the SAR operation. Noise shaping is adopted to suppress the comparator thermal and flicker noise. The prototype achieves a peak SNDR of 101dB over 1kHz bandwidth with a Schreier FOM of 178.9dB and can be configured to conventional SAR mode up to 5MS/s. The proposed techniques enable the application of power-efficient SAR ADCs for high-precision, multi-purpose sensor readout interfaces.Keywords
This publication has 4 references indexed in Scilit:
- Low Power Design Techniques for Single-Bit Audio Continuous-Time Delta Sigma ADCs Using FIR FeedbackIEEE Journal of Solid-State Circuits, 2014
- An 18 b 5 MS/s SAR ADC with 100.2 dB dynamic range2014
- 22.1 A 90GS/s 8b 667mW 64× interleaved SAR ADC in 32nm digital SOI CMOS2014
- A 90MS/s 11MHz bandwidth 62dB SNDR noise-shaping SAR ADC2012