Pitting Corrosion of Inconel 600 in Chloride and Thiosulfate Anion Solutions at Low Temperature
Authors:
- 1 February 1992
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 48 (2) , 147-158
Abstract
Pitting corrosion of mill annealed Inconel 600 was studied in aqueous chloride and chloride-thiosulfate solutions at low temperature. Potentiodynamic and potentiostatic polarization techniques were used to determine the characteristic pitting potentials for Inconel† 600 in chloride and chloride-thiosulfate media. The pitting potential, Enp, was evaluated in four different concentrations of sodium chloride between 0.1 and 0.0001 M. Enp decreased with increasing concentrations of the chloride ion. Immunity to pitting corrosion was evident at chloride levels below 0.0025 M without thiosulfate additions. Increasing thiosulfate concentrations resulted in improved chloride pitting resistance; however, low concentration (0.0001 M) thiosulfate additions reduced pitting resistance. The lowest concentrations of chloride ions with thiosulfate additions causing pitting were determined. The results of open circuit immersion test were consistent with that determined by use of the anodic polarization scan. The EDS data show that sulfur is enriched in pits; thiosulfate may play an important role in the processes of pit growth. Pit density and average pit depth increased with increasing concentrations of sodium chloride and temperature of solution. The probable mechanism of the processes leading to pitting of Inconel 600 in low temperature water is discussed.Keywords
This publication has 14 references indexed in Scilit:
- Pitting Corrosion Behavior of Alloy 800 in Chloride-Sulfate MediaCorrosion, 1987
- The kinetics of pit growth on alloy 600 in chloride solutions at high temperaturesCorrosion Science, 1987
- Pitting Corrosion of Inconel 600 in High-Temperature Water Containing CuCl2Corrosion, 1985
- Chemisorption and Catalysis in Polythionic/Thiosulfate Stress Corrosion CrackingJournal of the Electrochemical Society, 1985
- Pitting Corrosion of Inconel 600 in High Temperature Chloride Solution Under Controlled Hydrodynamic ConditionsCorrosion, 1985
- Chemical studies of polythionic acid stress-corrosion crackingCorrosion Science, 1983
- Effects of Sulfur Compounds on the Pitting Behavior of Type 304 Stainless Steel in Near-Neutral Chloride SolutionsCorrosion, 1982
- Pitting Corrosion of Nuclear Steam Generator MaterialsNuclear Technology, 1981
- Measurement and Evaluation of Pitting Corrosion1976
- Environmental Factors Affecting the Critical Potential for Pitting in 18–8 Stainless SteelJournal of the Electrochemical Society, 1966