Residual thermal stresses in injection molded products
Authors:
- 1 July 1996
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 36 (14) , 1886-1896
Abstract
Nonisothermal flow of a polymer melt in a cold mold cavity introduces stresses that are partly frozen‐in during solidification. Flow‐induced stresses cause anisotropy of mechanical, thermal, and optical properties, while the residual thermal stresses induce warpage and stress‐cracking. In this study, the influence of the holding stage on the residual thermal stress distribution is investigated. Calculations with a linear viscoelastic constitutive law are compared with experimental results obtained with the layer removal method for specimens of polystyrene (PS) and acrylonitrile butadiene‐styrene (ABS). In contrast to slabs cooled at ambient pressures, which show the well‐known tensile stresses in the core and compressive stresses at the surfaces, during the holding stage in injection molding, when extra molten polymer is added to the mold to compensate for the shrinkage, tensile stresses may develop at the surface, induced by the pressure during solidification.Keywords
This publication has 10 references indexed in Scilit:
- The computation of properties of injection-moulded productsProgress in Polymer Science, 1995
- The measurement of thermal stress distributions along the flow path in injection‐molded flat platesPolymer Engineering & Science, 1992
- Calculation of residual stresses in injection molded productsRheologica Acta, 1991
- The measurement and calculation of birefringence in quenched polycarbonate specimensPolymer, 1989
- Mechanism of Cooling Stress Build-Up in Injection Molding of Thermoplastic Polymers**International Polymer Processing, 1987
- A four‐node plate bending element based on Mindlin/Reissner plate theory and a mixed interpolationInternational Journal for Numerical Methods in Engineering, 1985
- A continuum mechanics based four‐node shell element for general non‐linear analysisEngineering Computations, 1984
- Toward a viscoelastic modelling of the injection molding of polymersRheologica Acta, 1980
- Orientation effects and cooling stresses in amorphous polymersPolymer Engineering & Science, 1978
- Injection moulding of plastics: Some ideas about the relationship between mould filling and birefringenceRheologica Acta, 1977