Direct ink writing of continuous SiO2 fiber reinforced wave-transparent ceramics
Authors:
Open Access
- 2 May 2020
- journal article
- research article
- Published by Tsinghua University Press in Journal of Advanced Ceramics
- Vol. 9 (4) , 403-412
Abstract
This article reports the first example of 3D printed continuous SiO2 fiber reinforced wave-transparent ceramic composites via an adaptation of direct ink writing technology to improve the mechanical and dielectric properties of ceramics. The ceramic inks showed good printability by adding nano-SiO2 powder. The effective continuous fiber-reinforced printing progress was achieved through the design and optimization of the coaxial needle structures by finite element simulation. After printing, the continuous fibers were evenly and continuously distributed in the matrix ceramics and the high molding precision for fiber reinforced composite was kept. It is demonstrated that 10 vol% continuous SiO2 fiber improved the bending strength of ceramics by about 27% better than that of the ceramics without fiber and the dielectric performance has also been greatly improved. The novel method unravels the potential of direct ink writing of continuous fiber reinforced wave-transparent ceramics with complex structures and improved properties.Keywords
This publication has 43 references indexed in Scilit:
- Fabrication of NiTi through additive manufacturing: A reviewProgress in Materials Science, 2016
- 3D Printing of Emulsions and Foams into Hierarchical Porous CeramicsAdvanced Materials, 2016
- Low temperature additive manufacturing of three dimensional scaffolds for bone-tissue engineering applications: Processing related challenges and property assessmentMaterials Science and Engineering: R: Reports, 2016
- Additive Manufacturing of Ceramic‐Based MaterialsAdvanced Engineering Materials, 2014
- Technical and commercial progress in the adoption of geopolymer cementMinerals Engineering, 2012
- Preparation and Characterization of Fiber‐Reinforced Aluminum Phosphate/Silica Composites with Interpenetrating Phase StructuresInternational Journal of Applied Ceramic Technology, 2011
- Study on the Dielectric Properties of Phosphoric Acid-Based GeopolymersMaterials Science Forum, 2010
- Synthesis and thermal behaviour of potassium sialate geopolymersMaterials Letters, 2003
- Carbon fiber/ceramic composite using aluminum phosphate with different P/Al molar ratiosJournal of Materials Science Letters, 2000
- New Aqueous Injection Molding Process for Ceramic PowdersJournal of the American Ceramic Society, 1989