Influence of Friction Stir Welding (FSW) on Mechanical and Corrosion Properties of AW-7020M and Aw-7020 Alloys
Open Access
- 1 September 2016
- journal article
- research article
- Published by Walter de Gruyter GmbH in Polish Maritime Research
- Vol. 23 (3) , 86-90
Abstract
Friction welding associated with mixing the weld material (FSW - Friction Stir Welding ) is an alternative to MIG and TIG welding techniques for Al-alloys. This paper presents experimental results obtained from static tension tests on specimens made of AW-7020M and AW-7020 alloys and their joints welded by using FSW method carried out on flat specimens, according to Polish standards : PN-EN ISO 4136:2011 and PN-EN ISO 6892-1:2010. Results of corrosion resistance tests are also presented. The tests were performed by using the electrochemical impedance spectroscopy (EIS). EIS measurement was conducted with the use of three-electrode system in a substitute sea water environment (3,5% NaCl - water solution). The impedance tests were carried out under corrosion potential. Voltage signal amplitude was equal to 10mV, and its frequency range - 100 kHz ÷ 0,1 Hz. Atlas 0531 EU&IA potentiostat was used for the tests. For the tested object an equivalent model was selected in the form of a substitute electric circuit. Results of the impedance spectroscopy tests are presented in the form of parameters which characterize corrosion process, as well as on Nyquist’s graphs together with the best-fit theoretical curve. Analysis of the test results showed that the value of charge transfer resistance through double layer , Rct , for the FSW-welded specimen , was lower than that for the basic material, and that much greater difference was found in the case of AW-7020M alloy. The impedance spectroscopy tests showed that both the FSW-welded joints and basic material of AW-7020M and AW-7020 alloys were characterized by a good resistance against electrochemical corrosion in sea water environment , and that FSW-welded joints revealed a greater corrosion rate.. The performed tests and subject-matter literature research indicate that application of FSW method to joining Al-alloys in shipbuilding is rational.Keywords
This publication has 7 references indexed in Scilit:
- Influence of Friction Stir Welding on Corrosion Properties of Aw-7020M Alloy in Sea WaterAdvances in Materials Science, 2015
- Effect of welding parameters on microstructure and mechanical properties of friction stir welded joints of AA7039 aluminum alloyMaterials & Design (1980-2015), 2012
- Analysis of possible shipbuilding application of friction stir welding (FSW) method to joining elements made of AlZn5Mg1 alloyPolish Maritime Research, 2009
- The effect of heat treatment on the structure and corrosion resistance of Al-Zn-Mg alloysPolish Maritime Research, 2008
- Low-cycle fatigue of friction stir welded Al–Mg alloysJournal of Materials Processing Technology, 2005
- FSW-Possibilities in ShipbuildingIndian Welding Journal, 2003
- Aluminium Alloy Structures1994