Diamond-Shaped Extended Fins for Heat Transfer Enhancement in a Double-Pipe Heat Exchanger: An Innovative Design
Open Access
- 26 June 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (13) , 5954
Abstract
Heat transfer enhancement in heat exchangers results in thermal efficiency and energy saving. In double-pipe heat exchangers (DPHEs), extended or augmented fins in the annulus of the two concentric pipes, i.e., at the outer surface of the inner pipe, are used to extend the surface of contact for enhancing heat transfer. In this article, an innovative diamond-shaped design of extended fins is proposed for DPHEs. This type of fin is considered for the first time in the design of DPHEs. The triangular-shaped and rectangular-shaped fin designs of DPHE, available in the literature, can be recovered as special cases of the proposed design. An h-adaptive finite element method is employed for the solution of the governing equations. The results are computed for various performance measures against the emerging parameters. The results dictate that the optimal configurations of the diamond-shaped fins in the DPHE for an enhanced heat transfer are recommended as follows: If around 4–6, 8–12, or 16–32 fins are to be placed in the DPHE, then the height of the fins should be 20%, 80%, or 100%, respectively, of the annulus width. If frictional loss of heat is also to be considered, then for fin-heights of 20–80% and 100% of the annulus width, the placement of 4 and 8 diamond-shaped fins, respectively, is recommended for an enhanced heat transfer. These recommendations are for the radii ratio (i.e., the ratio of the inner pipe radius to that of the outer pipe) of 0.25. The recommendations are be modified if the radii ratio is altered.Keywords
This publication has 21 references indexed in Scilit:
- Laminar convection in the annulus of a double-pipe with triangular finsComputers & Fluids, 2011
- Convective heat transfer in the thermal entrance region of finned double-pipeHeat and Mass Transfer, 2006
- Experimental study on the pressure drop and heat transfer characteristics of tubes with internal wave-like longitudinal finsHeat and Mass Transfer, 1999
- Heat transfer augmentation and pumping power in double-pipe heat exchangersExperimental Thermal and Fluid Science, 1994
- Conjugated Laminar Forced Convective Heat Transfer From Internally Finned TubesJournal of Heat Transfer, 1987
- Analysis of Laminar Flow and Heat Transfer in the Entrance Region of an Internally Finned Circular DuctJournal of Heat Transfer, 1985
- Laminar Heat Transfer in an Externally Finned Circular TubeJournal of Heat Transfer, 1980
- Analysis of Laminar Heat Transfer in Internally Finned Tubes with Uniform Outside Wall TemperatureJournal of Heat Transfer, 1980
- Heat Transfer in Internally Finned TubesJournal of Heat Transfer, 1976
- Fully developed viscous flow in internally finned tubesThe Chemical Engineering Journal, 1975