Multiple-parameter CMOS IC testing with increased sensitivity for I/sub DDQ/
Authors:
- K. RoyKRK. Roy
- C.F. HawkinsCHC.F. Hawkins
- V. DeVDV. De
- 7 October 2003
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 11 (5) , 863-870
Abstract
Technology scaling challenges the effectiveness of current-based test techniques such as I/sub DDQ/. Furthermore, existing leakage reduction techniques are not as effective in aggressively scaled technologies. We exploited intrinsic dependencies of transistor and circuit leakage on clock frequency, temperature, and reverse body bias (RBB) to discriminate fast ICs from defective ones. Transistor and circuit parameters were measured and correlated to demonstrate leakage-based testing solutions with improved sensitivity. We used a test IC with available body terminals for our experimental measurements. Our data suggest adopting a sensitive multiple-parameter test solution. For high performance IC applications, we propose a new test technique, I/sub DDQ/ versus F/sub MAX/ (maximum operating frequency), in conjunction with using temperature (or RBB) to improve the defect detection sensitivity. For cost sensitive applications, I/sub DDQ/ versus temperature test can be deployed. Our data show that temperature (cooling from 110/spl deg/C to room) improved sensitivity of I/sub DDQ/ versus F/sub MAX/ two-parameter test by more than an order of magnitude (13.8/spl times/). The sensitivity can also be tuned by proper selection of a temperature range to match a required defect per million (DPM) level.Keywords
This publication has 18 references indexed in Scilit:
- Current ratios: a self-scaling technique for production I/sub DDQ/ testing2003
- I/sub DDQ/ testing in deep submicron integrated circuits2003
- An histogram based procedure for current testing of active defects2003
- A high performance 180 nm generation logic technology2002
- Intrinsic leakage in low power deep submicron CMOS ICs2002
- So what is an optimal test mix? A discussion of the SEMATECH methods experiment2002
- Current signatures: application2002
- An 18-μA standby current 1.8-V, 200-MHz microprocessor with self-substrate-biased data-retention modeIEEE Journal of Solid-State Circuits, 1999
- Technology scaling behavior of optimum reverse body bias for standby leakage power reduction in CMOS IC's1999
- Technology and design challenges for low power and high performance1999