Osteochondral Grafting: Effect of Graft Alignment, Material Properties, and Articular Geometry
Authors:
- Darryl D. D’lImaDDDarryl D. D’lIma
- Peter C. ChenPCPeter C. Chen
- Clifford W. Colwell Jr.CJClifford W. Colwell Jr.
Open Access
- 6 August 2009
- journal article
- Published by Bentham Science Publishers Ltd. in The Open Orthopaedics Journal
- Vol. 3 (1) , 61-68
Abstract
Osteochondral grafting for cartilage lesions is an attractive surgical procedure; however, the clinical results have not always been successful. Surgical recommendations differ with respect to donor site and graft placement technique. No clear biomechanical analysis of these surgical options has been reported. We hypothesized that differences in graft placement, graft biomechanical properties, and graft topography affect cartilage stresses and strains. A finite element model of articular cartilage and meniscus in a normal knee was constructed. The model was used to analyze the magnitude and the distribution of contact stresses, von Mises stresses, and compressive strains in the intact knee, after creation of an 8-mm diameter osteochondral defect, and after osteochondral grafting of the defect. The effects of graft placement, articular surface topography, and biomechanical properties were evaluated. The osteochondral defect generated minimal changes in peak contact stress (3.6 MPa) relative to the intact condition (3.4 MPa) but significantly increased peak von Mises stress (by 110%) and peak compressive strain (by 63%). A perfectly matched graft restored stresses and strains to near intact conditions. Leaving the graft proud by 0.5 mm generated the greatest increase in local stresses (peak contact stresses = 6.7 MPa). Reducing graft stiffness and curvature of articular surface had lesser effects on local stresses. Graft alignment, graft biomechanical properties, and graft topography all affected cartilage stresses and strains. Contact stresses, von Mises stresses, and compressive strains are biomechanical markers for potential tissue damage and cell death. Leaving the graft proud tends to jeopardize the graft by increasing the stresses and strains on the graft. From a biomechanical perspective, the ideal surgical procedure is a perfectly aligned graft with reasonably matched articular cartilage surface from a lower load-bearing region of the knee.Keywords
This publication has 35 references indexed in Scilit:
- A cadaveric analysis of contact stress restoration after osteochondral transplantation of a cylindrical cartilage defectKnee Surgery, Sports Traumatology, Arthroscopy, 2008
- Arthroscopic Autologous Osteochondral Grafting for Cartilage Defects of the KneeThe American Journal of Sports Medicine, 2007
- Tibiofemoral Contact Mechanics after Serial Medial Meniscectomies in the Human Cadaveric KneeThe American Journal of Sports Medicine, 2006
- Association of cartilage defects with loss of knee cartilage in healthy, middle‐age adults: A prospective studyArthritis & Rheumatism, 2005
- Osteochondral Defects in the Human KneeThe American Journal of Sports Medicine, 2004
- Arthroscopic autogenous osteochondral transplantation for treating knee cartilage defects: A 2- to 5-year follow-up studyArthroscopy, 2004
- Human chondrocyte apoptosis in response to mechanical injuryOsteoarthritis and Cartilage, 2001
- How severe must repetitive loading be to kill chondrocytes in articular cartilage?Osteoarthritis and Cartilage, 2001
- Interspecies comparisons of in situ intrinsic mechanical properties of distal femoral cartilageJournal of Orthopaedic Research, 1991
- Meniscal tears: The effect of meniscectomy and of repair on intraarticular contact areas and stress in the human kneeThe American Journal of Sports Medicine, 1986