Effects of Charge Motion Control During Cold Start of SI Engines
Authors:
- 16 October 2006
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
An experimental study was performed to investigate the effects of various intake charge motion control valves (CMCVs) on mixture preparation, combustion, and hydrocarbon (HC) emissions during the cold start-up process of a port fuel injected spark ignition (SI) engine. Different charge motions were produced by three differently shaped plates in the CMCV device, each of which blocked off 75% of the engine's intake ports. Time-resolved HC, CO and CO2 concentrations were measured at the exhaust port exit in order to achieve cycle-by-cycle engine-out HC mass and in-cylinder air/fuel ratio. Combustion characteristics were examined through a thermodynamic burn rate analysis. Cold-fluid steady state experiments were carried out with the CMCV open and closed. Enhanced charge motion with the CMCV closed was found to shorten the combustion duration, which caused the location of 50% mass fraction burned (MFB) to occur up to 5° CA earlier for the same spark timing. By the use of the CMCV, significant improvements in combustion stability and fuel efficiency were also achieved with increased levels of spark retard mainly due to enhanced fuel-air mixing and relatively faster burning. Engine start-up experiments were conducted with three different geometric CMCVs using various fuel injection and spark timing strategies. The CMCV improved mixture preparation due to increased swirl and tumble intensities, which enhanced fuel transport, distribution, and evaporation. Flow bench and engine test results indicate that more fuel was evaporated with the CMCV geometry that produced moderate swirl and tumble intensities rather than high swirl or tumble alone. The effects of enhanced charge motion on combustion characteristics were decoupled from those on mixture preparation and were found to increase combustion stability and burning rate. Those combined effects of greater fuel evaporation and faster burning rate with the CMCV closed allowed strategies with reduced fuel injection and additional spark retard during cold start, resulting in a significant reduction in HC emissions. For the same in-cylinder air/fuel ratio profile, engine-out HC emissions following cold start-up were reduced by 18% during 0-3 seconds and by 7% during 3-20 seconds with the CMCV closed using reduced fuel injection and retarded spark timing strategy.Keywords
This publication has 9 references indexed in Scilit:
- Mixture Preparation and Hydrocarbon Emissions Behaviors in the First Cycle of SI Engine CrankingSAE International Journal of Advances and Current Practices in Mobility, 2002
- Spark Ignition Engine Hydrocarbon Emissions Behaviors in Stopping and RestartingSAE International Journal of Advances and Current Practices in Mobility, 2002
- Fuel Metering Effects on Hydrocarbon Emissions and Engine Stability During Cranking and Start-up in a Port Fuel Injected Spark Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 2000
- Evaporation of In-Cylinder Liquid Fuel Droplets in an SI Engine: A Diagnostic-Based Modeling StudySAE International Journal of Advances and Current Practices in Mobility, 1999
- Cycle-by-Cycle Analysis of HC Emissions During Cold Start of Gasoline EnginesSAE International Journal of Advances and Current Practices in Mobility, 1995
- Mixture Preparation and HC Emissions of a 4-Valve Engine with Port Fuel Injection During Cold Starting and Warm-upSAE International Journal of Advances and Current Practices in Mobility, 1995
- Evaluation of a One-Zone Burn-Rate Analysis Procedure Using Production SI Engine Pressure DataSAE International Journal of Advances and Current Practices in Mobility, 1993
- Speciated Hydrocarbon Emissions of SI Engine During Cold Start and Warm-upSAE International Journal of Advances and Current Practices in Mobility, 1993
- A Model for Predicting Residual Gas Fraction in Spark-Ignition EnginesSAE International Journal of Advances and Current Practices in Mobility, 1993