Influence of precipitate microstructure on flow and forming properties of an aluminum alloy sheet
Authors:
- F. BarlatFBF. Barlat
- A.K. VasudévanAVA.K. Vasudévan
- 1 March 1991
- journal article
- Published by Elsevier in Acta Metallurgica et Materialia
- Vol. 39 (3) , 391-400
Abstract
No abstract availableKeywords
This publication has 19 references indexed in Scilit:
- Structure and deformation behavior ofT 1 precipitate plates in an Al- 2Li- 1 Cu alloyMetallurgical Transactions A, 1988
- The plastic anisotropy of two-phase aluminium alloys—II. anisotropic behaviour in load-reversal testsActa Metallurgica, 1982
- The plastic anisotropy of two-phase aluminium alloys—I. Anisotropy in unidirectional deformationActa Metallurgica, 1981
- An automated hydraulic bulge testerJournal of Applied Metalworking, 1981
- Measurement and analysis of plane-strain work hardeningMetallurgical Transactions A, 1980
- Directionality in a precipitation-hardened alloyMetallurgical Transactions A, 1977
- The anisotropy of age-hardened Al-4 pct Cu single crystals during plane-strain compressionMetallurgical Transactions, 1972
- Description of Crystallite Orientation in Polycrystalline Materials. III. General Solution to Pole Figure InversionJournal of Applied Physics, 1965
- CXXVIII. A theoretical derivation of the plastic properties of a polycrystalline face-centred metalJournal of Computers in Education, 1951
- XLVI. A theory of the plastic distortion of a polycrystalline aggregate under combined stresses.Journal of Computers in Education, 1951