Theoretical Modeling for Microgrooved Journal Bearings Under Mixed Lubrication
- 1 October 2010
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 132 (4) , 042101
Abstract
In designing of engine bearings for automobiles, we need to establish a mixed lubrication model that considers the solid-to-solid contact between journal surfaces and bearing surfaces with microgroove. However, as far as we know, there is no literature treating such problems. This paper describes theoretical modeling for microgrooved bearings under the mixed lubrication conditions with experimental verifications and prediction of performance in the actual engine bearings. In this modeling, a sectional shape of the microgrooved bearing was approximated to be a circular sectional shape. Contact pressure between the journal surfaces and the bearing surfaces with microgroove was calculated using the Hertzian contact model and the effects of elastic deformation of bearing surface due to hydrodynamic and contact pressures were considered. A numerical calculation model was developed to predict bearing performance under the mixed lubrication condition in microgrooved journal bearings. Oil film thickness distributions, hydrodynamic and contact pressure distributions, and real contact area between the journal surfaces and the bearing surfaces with microgroove were obtained simultaneously by the theoretical model. Moreover, friction coefficients under mixed lubrication conditions were determined by the theoretical model and the calculated results were compared with experimental results using test rig. The calculated results successfully agreed with the experimental results and the applicability of the model was verified. Moreover, the model was applied to predict the performance of engine bearings. In the numerical results, real contact area occurred relative widely under low-speed conditions when engine was started but friction loss was not excessive because of low shearing velocity. On the other hand, under high-speed engine conditions, the friction loss was large in spite of narrow real contact area because of high shearing velocity. Under both low-speed and high-speed conditions, the real contacts will occur severely at the edge of the bearing in the axial direction and at the bearing angles from 50 deg to 110 deg in circumferential direction. In addition, an appropriate design of the microgrooved bearing was examined under mixed lubrication conditions. In the design of the microgrooves, a cooling effect and an enough amount of oil flow to the contact area are needed. As the results from parametric studies using present theoretical model, an influence of the depth of the microgroove was the largest on the cooling effect and the enough amount of oil flow. In the case of typical operation condition, it was found that of the groove depth was the most appropriate.
Keywords
This publication has 10 references indexed in Scilit:
- Mixed Elastohydrodynamic Lubrication in a Partial Journal Bearing—Comparison Between Deterministic and Stochastic ModelsJournal of Tribology, 2006
- Mass Conserving Elastohydrodynamic Lubrication Model of Engine Bearings Having Regular StriationsTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 2006
- A Study of Microgrooved Bearing Performance by using Numerical AnalysisSAE International Journal of Advances and Current Practices in Mobility, 2000
- Performance of Plain Bearings with Circumferential MicrogroovesTribology Transactions, 1996
- A Mixed Lubrication Model for Journal Bearings with a Thin Soft Coating—Part I: Contact and Lubrication AnalysisTribology Transactions, 1995
- The Effect of Compliance On Peak Oil Film Pressure in Connecting Rod Bearings1993
- A Numerical Analysis for Piston Skirts in Mixed Lubrication—Part I: Basic ModelingJournal of Tribology, 1992
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978
- The Hydrodynamic Lubrication of Rough Journal BearingsJournal of Lubrication Technology, 1973
- Elastische Berührung zweier HalbräumeForschung im Ingenieurwesen, 1939