The Effects of Wear Debris under Fluid Flow Environment on Fretting Wear Mechanism of Nuclear Fuel Cladding Tube Supported by Supporting Grid
Authors:
- 16 April 2010
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 53 (3) , 452-462
Abstract
Nuclear cladding tubes are subjected to low-amplitude flow-induced vibrations (FIVs). Fretting wear occurs when two contacting surfaces are exposed to very low oscillation. Because nuclear cladding tubes are damaged by this fretting wear, it is necessary to try to evaluate the lifetime and improve the wear resistance of the tube. For this purpose, it is very important to clearly understand the damage mechanism of the tubes. Therefore, the present study undertook fretting-wear tests to investigate how the fluid that flows between the tube and the supporting grid affects the fretting wear. The governing damage mechanism consisted of abrasive wear and surface detachment behavior. In the case of the fluid flow environment, most of the wear debris was ejected from the contacting surfaces and this mode had a large effect on the maximum wear depth of the tube or wear amount. Additionally, the tests were performed under the water flow state as well as the water/air flow state. The result is that if the fluid flow exists, severe wear occurs through some mechanisms, such as two-body abrasion; further, the fluid flow decreases the contact load and attenuates the kinetics of oxidation. Because the severe wear due to two-body abrasion interrupted the formation of oxide film, wear amount was increased. Furthermore, even in the case of water/air flow environment, the worn surface was hardly oxidized due to extremely severe wear.Keywords
This publication has 20 references indexed in Scilit:
- Impact of contact size and complex gross–partial slip conditions on Ti–6Al–4V/Ti–6Al–4V fretting wearTribology International, 2009
- On the geometry of the fuel rod supports concerning a fretting wear failureNuclear Engineering and Design, 2008
- Gaseous Cavitation and Wear in Lubricated Fretting ContactsTribology Transactions, 2008
- Friction and Wear Characteristics Due to Stick-Slip under Fretting ConditionsTribology Transactions, 2007
- Friction and wear of Inconel 690 and Inconel 600 for steam generator tube in room temperature waterNuclear Engineering and Design, 2003
- Study on transition between fretting and reciprocating sliding wearWear, 2001
- Lubrication in fretting—a reviewWear, 1999
- The analysis and prevention of failure in railway axlesInternational Journal of Fatigue, 1998
- The fretting wear of mild steel from room temperature to 200°CWear, 1972
- The fretting corrosion of mild steelProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1956