Evaluation of Ozone Pretreatment on Flux Parameters of Reverse Osmosis for Surface Water Treatment

Authors:
Publisher website
Google Scholar
Abstract
This research details the effects of ozone pretreatment on flux of a reverse osmosis membrane. Initial tests were conducted to determine the effects of ozonation on solids removal, turbidity, and chemical oxygen demand concentrations using various doses on a simulated surface water. These initial tests showed that the best reduction of solids in the 2–5 microns range was at 0.30 mg/L of ozone. Next, a series of bench scale tests was run for 62.5 hours using a standard reverse osmosis system under constant pressure with three pre-ozonation doses and a no ozone baseline dose. Temporal models were developed using the flux data from these tests to determine the effects of operating hours and ozone dosage on flux. It was found that the laboratory data were not linear and followed power law models. Statistical analysis was used to determine the significance of each ozone dose on the four developed models. The change in flux over the 62.5 operating hours with an ozone dosage of 0.30 mg/L showed the lowest flux change. Last, the models were tested using Hermia's filtration models and resistance versus time data to determine the type of membrane fouling that existed. It was concluded that the major fouling was pore blockage. This work demonstrated that ozone pretreatment is effective prior to use with reverse osmosis since it shows a better solid and organic removal rate as well as decreased flux and resistance changes over time.

This publication has 26 references indexed in Scilit: