Comparative Study of Tribological Behavior of TiN Hard Coatings Deposited by Various PVD Deposition Techniques
Open Access
Abstract
In this paper, we present a comparative study of tribological properties of TiN coatings deposited by low-voltage electron beam evaporation, magnetron sputtering and cathodic arc deposition. The correlation of tribological behavior of these coatings with their intrinsic properties and friction condition was studied. The influence of surface topography and the surrounding atmosphere was analyzed in more detail. We limited ourselves to the investigation of tribological processes that take place in the initial phase of the sliding test (the first 1000 cycles). A significant difference in the initial phase of the sliding test of three types of TiN coatings was observed. We found that nodular defects on the coating surface have an important role in this stage of the sliding test. The tribological response of TiN coatings, prepared by cathodic arc deposition, is also affected by the metal droplets on the coating surface, as well as those incorporated in the coating itself. Namely, the soft metal droplets increase the adhesion component of friction. The wear rates increased with the surface roughness of TiN coatings, the most for coatings prepared by cathodic arc deposition. The influences of post-polishing of the coating and the surrounding atmosphere were also investigated. The sliding tests on different types of TiN coatings were conducted in ambient air, oxygen and nitrogen. While oxygen promotes tribo-chemical reactions at the contact surface of the coating, nitrogen suppresses them. We found that the wear rate measured in ambient air, compared with that in an oxygen atmosphere, was lower. The difference is probably due to the influence of humidity in the ambient air. On the other hand, wear rates measured in a nitrogen atmosphere were much lower in comparison with those measured in an oxygen or ambient air atmosphere.Keywords
Funding Information
- The Slovenian Research and Innovation Agency (P2-0082)
- European Regional Development Funds (CENN Nanocenter, OP13.1.1.2.02.006)
This publication has 46 references indexed in Scilit:
- Comparative study of surface roughness and tribological behavior during running-in period of hard coatings deposited by lateral rotating cathode arcWear, 2010
- Influence of surface topography of arc-deposited TiN and sputter-deposited WC/C coatings on the initial material transfer tendency and friction characteristics under dry sliding contact conditionsSurface and Coatings Technology, 2009
- Stress and preferred orientation in nitride-based PVD coatingsSurface and Coatings Technology, 2008
- Friction and wear of coated surfaces — scales, modelling and simulation of tribomechanismsSurface and Coatings Technology, 2007
- Effects of substrate bias and argon flux on the structure of titanium nitride films deposited by filtered cathodic arc plasmaPhysica Status Solidi (a), 2004
- On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviourWear, 2000
- Tribo-layer formation during sliding wear of TiN coatingsWear, 2000
- A novel pulsed magnetron sputter technique utilizing very high target power densitiesSurface and Coatings Technology, 1999
- Microstructures of TiN films grown by various physical vapour deposition techniquesSurface and Coatings Technology, 1991
- Hard decorative coatings by reactive physical vapor deposition: 12 Years of developmentSurface and Coatings Technology, 1989