A Pre-peak Elastoplastic Damage Model of Gosford Sandstone Based on Acoustic Emission and Ultrasonic Wave Measurement
Open Access
- 24 May 2022
- journal article
- research article
- Published by Springer Nature in Rock Mechanics and Rock Engineering
- Vol. 55 (8) , 4819-4838
Abstract
The determination of internal material damage is always an arduous challenge. Non-destructive monitoring methods show great potential in quantitatively determining the internal material properties, whereas most of the studies relying on external observations remain in a qualitative stage. They either violate the basic thermodynamic assumptions or are difficult to guide engineering practice. In this paper, following the theory of continuum mechanics, an elastoplastic damage model based on non-destructive monitoring methods (i.e., acoustic emission and ultrasonic wave velocity measurement) has been developed. To capture the continuous and precise damage evolution inside rock mass, P wave velocity obtained by ultrasonic wave measurement was utilised and then considered as an input for the proposed elastoplastic damage model. Triaxial loading test results on six Gosford sandstone samples were analysed first to characterise critical stresses along the stress–strain loading curves, such as crack closure stress, stable crack propagation stress and unstable crack propagation stress. The drop of ultrasonic wave velocity can be seen as an indicator to represent the damage evolution inside rock material. Damage initiation is also closely related to the confining stress and dilation induced volumetric expansion. The test results also suggested that the Drucker–Prager criterion is sufficient to describe the plastic yielding surface and the following material hardening. A non-associated plastic flow assumption was adopted, considering the essence of microcrack shearing in rock failure and the effect of hydrostatic pressure on plastic deformation. A modified Drucker–Prager plastic potential was also introduced to track the orientation of plastic increment with material hardening. A scalar damage variable was derived from ultrasonic wave measurement results to indirectly represent the deterioration of rock properties (modulus). The proposed model was used to match lab test results with high consistency, and the main features of rock behaviour in triaxial loading tests were successfully captured by the model. Finally, the damage evolution of rock samples was analysed, which indicates that damage is dependent on its conjugate force, namely damage energy release rate Y. This study proves that P wave velocity can be an effective approach to measure and forecast the internal damage evolution inside rock mass, which has broad prospects for engineering applications.Keywords
Funding Information
- State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (SKLGP2021K002)
- University of New South Wales (University International Postgraduate Award)
- University of New South Wales
This publication has 85 references indexed in Scilit:
- Evaluation of Methods for Determining Crack Initiation in Compression Tests on Low-Porosity RocksRock Mechanics and Rock Engineering, 2012
- Statistical damage model with strain softening and hardening for rocks under the influence of voids and volume changesCanadian Geotechnical Journal, 2010
- Statistical Damage Mechanics and Extreme Value TheoryInternational Journal of Damage Mechanics, 2007
- Modeling of elastoplastic damage behavior of a claystoneInternational Journal of Plasticity, 2003
- Modeling of Crack Initiation, Propagation and Coalescence in Uniaxial CompressionRock Mechanics and Rock Engineering, 2000
- Constitutive and damage evolution equations of elastic-brittle materials based on irreversible thermodynamicsInternational Journal of Mechanical Sciences, 1997
- Effective Elastic Properties of Cracked Solids: Critical Review of Some Basic ConceptsApplied Mechanics Reviews, 1992
- Non-associated plastic flow in single crystalsJournal of the Mechanics and Physics of Solids, 1992
- Relationship among fatigue strength, mean grain size and compressive strength of a rockRock Mechanics and Rock Engineering, 1988
- Bounds to bifurcation stresses in solids with non-associated plastic flow law at finite strainJournal of the Mechanics and Physics of Solids, 1981