Polarity Assessment of Thermoresponsive Poly(NIPAM-co-NtBA) Copolymer Films Using Fluorescence Methods
Open Access
- 24 February 2010
- journal article
- research article
- Published by Springer Nature in Journal of Fluorescence
- Vol. 20 (3) , 719-731
Abstract
The in-situ, non-contact, and non-destructive measurement of the physicochemical properties such as the polarity of thin, hydrophilic polymer films is desirable in many areas of polymer science. Polarity is a complex factor and encompasses a range of non-covalent interactions including dipolarity/polarizability and hydrogen bonding. A polarity measurement method based on fluorescence would be ideal, but the key challenge is to identify suitable probes which can accurately measure specific polarity related parameters. In this manuscript we assess a variety of fluorophores for measuring the polarity of a series of relatively hydrophilic, thermoresponsive N-isopropylacrylamide/N-tert-butylacrylamide (NIPAM/NtBA) copolymers. The emission properties of both pyrene and 3-Hydroxyflavone (3-HF) based fluorophores were measured in dry polymer films. In the case of pyrene, a relatively weak, linear relationship between polymer composition and the ratio of the first to the third vibronic band of the emission spectrum (I1/I3) is observed, but pyrene emission is very sensitive to temperature and thus not suitable for robust polarity measurements. The 3-HF fluorophores which can undergo an excited-state intramolecular proton transfer (ESIPT) reaction have a dual band fluorescence emission that exhibits strong solvatochromism. Here we used 4′-diethylamino-3-hydroxyflavone (FE), 5,6-benzo-4′-diethylamino-3-hydroxyflavone (BFE), and 4´-diethylamino-3-hydroxy-7-methoxyflavone (MFE). The log ratio of the dual band fluorescence emission (log (IN*/IT*)) of 3-HF doped, dry, NIPAM-NtBA copolymer films were found to depend linearly on copolymer composition, with increasing hydrophobicity (greater NtBA fraction) leading to a decrease in the value of log (IN*/IT*). However, the ESIPT process in the polymer matrix was found to be irreversible, non-equilibrated and occurs over a much longer timescale in comparison to the results previously reported for liquid solvents.Keywords
This publication has 44 references indexed in Scilit:
- Measuring the Micro-Polarity and Hydrogen-Bond Donor/Acceptor Ability of Thermoresponsive N-Isopropylacrylamide/N-tert-Butylacrylamide Copolymer Films Using Solvatochromic IndicatorsApplied Spectroscopy, 2009
- Bilayer polarity and its thermal dependency in the ℓo and ℓd phases of binary phosphatidylcholine/cholesterol mixturesBiochimica et Biophysica Acta (BBA) - Biomembranes, 2007
- Modulation of the solvent-dependent dual emission in 3-hydroxychromones by substituentsNew Journal of Chemistry, 2003
- Broadening of the fluorescence spectra of hydrocarbons in ethylene-vinyl acetate copolymers and the dynamics of the glass transitionJournal of Photochemistry and Photobiology A: Chemistry, 2003
- Ultrasensitive fluorescent probe for the hydrophobic range of solvent polaritiesAnalytica Chimica Acta, 2002
- Relating the polarity-dependent fluorescence response of pyrene to vibronic coupling. Achieving a fundamental understanding of the py polarity scaleThe Journal of Physical Chemistry, 1995
- Temperature Effect on Pyrene as a Polarity Probe for Supercritical Fluid and Liquid SolutionsApplied Spectroscopy, 1994
- Reversal of excitation behavior of proton-transfer vs. charge-transfer by dielectric perturbation of electronic manifoldsThe Journal of Physical Chemistry, 1993
- Solvatochromism: a new method for polymer characterizationMacromolecules, 1990
- Py and BPe solvent polarity scales: effect of temperature on pyrene and benzo[ghi]perylene fluorescence spectraThe Analyst, 1988