Prediction of impinging spray penetration and cone angle under different injection and ambient conditions by means of CFD and ANNs
- 6 April 2017
- journal article
- research article
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 39 (10) , 3863-3880
Abstract
No abstract availableKeywords
This publication has 34 references indexed in Scilit:
- A CFD study on spray characteristics of heavy fuel oil-based microalgae biodiesel blends under ultra-high injection pressuresMeccanica, 2016
- Influence of Ultra-high Injection Pressure and Nozzle Hole Diameter on Diesel Flow and Spray Characteristics under Evaporating ConditionJournal of ILASS-Korea, 2015
- Numerical investigation of the effects of chamber backpressure on HFO spray characteristicsInternational Journal of Automotive Technology, 2015
- Three-dimensional LES modeling of induced gas motion under the influence of injection pressure and ambient density in an ultrahigh-pressure diesel injectorJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2014
- Spray-induced air motion in single and twin ultra-high injection diesel spraysFuel, 2014
- Impact of nozzle holes configuration on fuel spray, wall impingement and NOx emission of a diesel engine for biodiesel–diesel blend (B20)Applied Thermal Engineering, 2014
- Transient Rate of Injection Effects on Spray DevelopmentSAE International Journal of Advances and Current Practices in Mobility, 2013
- Experimental and analytical study on biodiesel and diesel spray characteristics under ultra-high injection pressureInternational Journal of Heat and Fluid Flow, 2010
- Comparison of experimental and predicted atomization characteristics of high-pressure diesel spray under various fuel and ambient temperatureJournal of Mechanical Science and Technology, 2010
- Using spray momentum flux measurements to understand the influence of diesel nozzle geometry on spray characteristicsFuel, 2005