Large-dynamic-range MEMS Electret Energy Harvester with Combined Gap-closing/Overlapping-area-change Electrodes
Authors:
- Qianyan FuQFQianyan Fu
- Yuji SuzukiYSYuji Suzuki
Open Access
- 4 December 2013
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 476 (1) , 012112
Abstract
A novel in-plane MEMS electret energy harvester with combined electrodes of overlapping-area-change and gap-closing types is proposed for large output power both at low and high vibration accelerations. An early prototype has been successfully micro-fabricated with the single layer silicon-on-insulator process. Soft-X-ray charging is employed to establish uniform surface potential around 60 V on vertical electrets on the sidewall of the comb fingers. Up to 1.19 μW output power has been obtained at 552 Hz and 2.15 g acceleration oscillations, which corresponds to the effectiveness as high as 27.2%.Keywords
This publication has 7 references indexed in Scilit:
- Bistable springs for wideband microelectromechanical energy harvestersApplied Physics Letters, 2013
- Electret charging method based on soft X-ray photoionization for MEMS transducersIEEE Transactions on Dielectrics and Electrical Insulation, 2012
- Recent progress in MEMS electret generator for energy harvestingIEEJ Transactions on Electrical and Electronic Engineering, 2011
- A MEMS electret generator with electrostatic levitation for vibration-driven energy-harvesting applicationsJournal of Micromechanics and Microengineering, 2010
- Fabrication, characterization and modelling of electrostatic micro-generatorsJournal of Micromechanics and Microengineering, 2009
- Energy Harvesting From Human and Machine Motion for Wireless Electronic DevicesProceedings of the IEEE, 2008
- Architectures for Vibration-Driven Micropower GeneratorsJournal of Microelectromechanical Systems, 2004