Arc enhanced laser melt injection WC particles on Al surface
Authors:
- 1 May 2013
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 29 (4) , 296-299
Abstract
In order to overcome the difficulties of laser melt injection (LMI) on aluminium alloys, the process of tungsten inert gas (TIG) arc enhanced LMI ceramic particles was developed. The influence of process parameters, including laser power, TIG current, the direction of powder feeding, the carrier gas flow of powder and the shield gas flow of TIG, was investigated. The results have shown that to achieve appropriate surface enhancement effect, the powder should be fed from the back side of the laser beam. The depth of the arc enhanced LMI layer increases monotonously with increasing TIG current. The depth of the LMI layer increases first and then decreases with increasing laser power. The carrier gas flow and gas flow of TIG should be matched. Through optimisation of process parameters, WCp/Al layer was prepared successfully on the surface of aluminium alloy. The microstructure of the surface layer prepared by arc enhanced LMI was analysed.Keywords
This publication has 7 references indexed in Scilit:
- Performance of a cutting tool made of steel matrix surface nano-composite produced by in situ laser melt injection technologyJournal of Materials Processing Technology, 2011
- In-situ synthesis of a carbide reinforced steel matrix surface nanocomposite by laser melt injection technology and subsequent heat treatmentSurface and Coatings Technology, 2009
- Electron microscopy study of reaction layers between single-crystal WC particle and Ti–6Al–4V after laser melt injectionActa Materialia, 2009
- WCp/Fe metal matrix composites produced by laser melt injectionSurface and Coatings Technology, 2008
- Improving the Wear Resistance of a Magnesium Alloy by Laser Melt InjectionMATERIALS TRANSACTIONS, 2001
- Laser melt injection in aluminum alloys: on the role of the oxide skinActa Materialia, 2000
- Electron microscopy of reaction layers between SiC and Ti–6Al–4V after laser embeddingActa Materialia, 1998