The influence of Si on the microstructure and sintering behavior of ultrafine WC
- 10 July 2012
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 92 (32) , 3950-3967
Abstract
The microstructure of sintered nanoscale tungsten carbide powders with 1 wt % Si addition was found to be populated by an abnormally large number of elongated grains. Interrupted sintering experiments were conducted to clarify the origins of the excessive abnormal grain growth seen in the microstructure. It was observed that rapid coarsening occurred at high temperatures owing to the formation of a liquid phase. However, the grain shape evolution during this coarsening period was found to be a consequence of excessive stacking faults and micro twins on the basal planes probably generated by reaction of WC with Si. Analyses of the microstructures and the isothermal and non isothermal coarsening behaviors suggested that the platelet morphology evolved by defect-assisted nucleation and growth on faceted grains. Based on experimental evidence from samples interrupted at low temperatures and crystal growth theories, we discuss the possible mechanisms that eventually led to the rampant platelet-type morphology. Further, the influence of such rapid grain growth on the shrinkage rate during sintering is also discussed. In comparison with the cyclic coarsening-densification process of sintering in pure nanoscale WC, the addition of Si leads to only two distinct sintering stages: either densification dominated or coarsening dominated. Concurrent densification and coarsening cannot be sustained particularly in the presence of a liquid phase that significantly enhances coarsening.Keywords
This publication has 20 references indexed in Scilit:
- Synthesis, sintering, and mechanical properties of nanocrystalline cemented tungsten carbide – A reviewInternational Journal of Refractory Metals and Hard Materials, 2009
- SPS, binderless WC powders, and the problem of sub carbideMetal Powder Report, 2008
- Abnormal grain growth of WC with small amount of cobaltPhilosophical Magazine, 2007
- Growth behavior of rounded (Ti,W)C and faceted WC grains in a Co matrix during liquid phase sinteringActa Materialia, 2005
- Growth morphology and mechanism of primary TiC carbide in laser clad TiC/FeAl composite coatingMaterials Letters, 2003
- Growth morphology and mechanism of MC carbide under quasi-rapid solidification conditionsScience and Technology of Advanced Materials, 2001
- The shape of WC crystals in cemented carbidesMaterials Science and Engineering: A, 1998
- Particle growth by coalescence during liquid phase sintering of Fe-CuActa Metallurgica, 1984
- Analysis of particle growth by coalescence during liquid phase sinteringActa Metallurgica, 1984
- The effect of cobalt content on the microstructure of liquid-phase sintered TaCCo alloysMaterials Science and Engineering, 1974