Ion Transport and Thermomechanical Properties of SrFe(Al)O[sub 3−δ]–SrAl[sub 2]O[sub 4] Composite Membranes
Open Access
- 1 January 2006
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 153 (6) , J50-J60
Abstract
Moderate additions of monoclinic SrAl2O4SrAl2O4 to perovskite-type SrFe(Al)O3−δSrFe(Al)O3−δ mixed conductors improve the sinterability and thermomechanical properties, including the thermal shock resistance, Vickers hardness, and fracture toughness, and decrease thermal expansion. The iron solubility in SrAl2O4SrAl2O4 , a mixed ionic and n-type electronic conductor with insulating properties, is lower than 5%. The total conductivity of SrAl2O4SrAl2O4 ceramics in air varies in the range 10−7–10−5S∕cm10−7–10−5S∕cm at 973–1223K973–1223K . The transport properties and phase stability of dual-phase (SrFe)1−x(SrAl2)xOz(SrFe)1−x(SrAl2)xOz (x=0.3–0.7)(x=0.3–0.7) composite membranes, where the partial dissolution of strontium aluminate in the ferrite phase leads to formation of A-site-deficient Sr1−yFe1−2yAl2yO3−δSr1−yFe1−2yAl2yO3−δ (y≈0.08–0.12)(y≈0.08–0.12) , are determined by the perovskite component. The total conductivity and Seebeck coefficient oxygen partial pressure dependencies exhibit general trends typical for SrFeO3SrFeO3 -based solid solutions. Although the conductivity and oxygen permeability of (SrFe)1−x(SrAl2)xOz(SrFe)1−x(SrAl2)xOz composites decrease with increasing xx , the permeation fluxes through (SrFe)0.7(SrAl2)0.3Oz(SrFe)0.7(SrAl2)0.3Oz ceramics are comparable to those through single-phase SrFe0.7Al0.3O3−δSrFe0.7Al0.3O3−δ . Under high pO2pO2 gradients such as air/ (H2–H2O)(H2–H2O) , the oxygen transport is limited by surface-related processes, enabling stable operation of (SrFe)0.7(SrAl2)0.3Oz(SrFe)0.7(SrAl2)0.3Oz membranes. This composition was selected for fabrication of tubular membranes by the cold isostatic pressing. Surface modification of (SrFe)0.7(SrAl2)0.3Oz(SrFe)0.7(SrAl2)0.3Oz in order to enhance the exchange kinetics was found inappropriate from a stability point of view.Keywords
This publication has 34 references indexed in Scilit:
- Limitations and potentials of oxygen transport dense and porous ceramic membranes for oxidation reactionsCatalysis Today, 2005
- Mössbauer Spectra and Catalytic Behaviorof Perovskite-like SrFe0.7Al0.3O3-δCatalysis Letters, 2005
- Oxygen Permeability and Thermal Expansion of Ferrite-Based Mixed Conducting CeramicsDefect and Diffusion Forum, 2004
- Oxygen permeation through oxygen ionic or mixed-conducting ceramic membranes with chemical reactionsJournal of Membrane Science, 2004
- Mixed conductivity and stability of A-site-deficient Sr(Fe,Ti)O 3-δ perovskitesJournal of Solid State Electrochemistry, 2002
- Oxygen Permeability and Ionic Conductivity of Perovskite-Related La[sub 0.3]Sr[sub 0.7]Fe(Ga)O[sub 3−δ]Journal of the Electrochemical Society, 2002
- Influence of gas flow rate on oxygen flux measurements for dense oxygen conducting ceramic membranesSolid State Ionics, 2000
- Cubic-stabilized zirconia and alumina composites as electrolytes in planar type solid oxide fuel cellsSolid State Ionics, 1994
- Thermodynamic data from redox reactions at high temperatures. I. An experimental and theoretical assessment of the electrochemical method using stabilized zirconia electrolytes, with revised values for the Fe-?FeO?, Co-CoO, Ni-NiO and Cu-Cu2O oxygen buffers, and new data for the W-WO2 bufferContributions to Mineralogy and Petrology, 1993
- Glycine-nitrate combustion synthesis of oxide ceramic powdersMaterials Letters, 1990