Impact of metal silicide precipitate dissolution during rapid thermal processing of multicrystalline silicon solar cells
- 16 September 2005
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 87 (12) , 121918
Abstract
Synchrotron-based analytical x-ray microprobe techniques were employed to study the dissolution of iron, copper, and nickel silicide precipitates at structural defects in cast multicrystalline silicon in response to rapid thermal processing (RTP). A direct correlation was observed between iron silicide precipitate dissolution, increased minority carrier recombination, and decreased device performance after high-temperature RTP. In contrast, iron precipitates comparable in size to as-grown material remained after lower-temperature RTP ; in this case the material exhibited higher minority carrier diffusion length and better solar cell performance. RTP at both temperatures effectively dissolved nickel and copper silicide precipitates. It is concluded that iron dissolved from structural defect reservoirs detrimentally affects the cell performance, likely by forming distributed point defects and smaller precipitates. For cast multicrystalline silicon, higher performance can be expected by inhibiting the dissolution of these precipitates, i.e., by reducing the time and/or temperature of processing steps.
Keywords
This publication has 10 references indexed in Scilit:
- Synchrotron-based investigations of the nature and impact of iron contamination in multicrystalline silicon solar cellsJournal of Applied Physics, 2005
- Analysis of copper-rich precipitates in silicon: Chemical state, gettering, and impact on multicrystalline silicon solar cell materialJournal of Applied Physics, 2005
- Transition-metal profiles in a multicrystalline silicon ingotJournal of Applied Physics, 2005
- SHORT COMMUNICATION: ACCELERATED PUBLICATION: Multicrystalline silicon solar cells exceeding 20% efficiencyProgress in Photovoltaics: Research and Applications, 2004
- High-efficiency solar cells on edge-defined film-fed grown (18.2%) and string ribbon (17.8%) silicon by rapid thermal processingApplied Physics Letters, 2004
- Applications of synchrotron radiation X-ray techniques on the analysis of the behavior of transition metals in solar cells and single-crystalline silicon with extended defectsPhysica B: Condensed Matter, 2003
- Metal content of multicrystalline silicon for solar cells and its impact on minority carrier diffusion lengthJournal of Applied Physics, 2003
- Synchrotron-based impurity mappingJournal of Crystal Growth, 2000
- Modeling of gettering of precipitated impurities from Si for carrier lifetime improvement in solar cell applicationsJournal of Applied Physics, 1999
- Hydrogen passivation of newly developed EMC-multi-crystalline siliconMaterials Science and Engineering: B, 1999