Electrochemical Determination of Arsenic Using Silver Nanoparticles
- 21 September 2018
- journal article
- research article
- Published by Wiley in Electroanalysis
- Vol. 30 (11) , 2738-2743
Abstract
In the present work, silver colloid was produced by chemical reduction of silver salt (silver nitrate) using citrates in aqueous solution. UV‐Vis spectrophotometry indicated the formation of nanoparticles. The surface plasmon resonance peak in absorption spectra of the silver colloidal solution showed an absorption maximum at 435 nm. The dynamic light scattering and zeta potential measurements showed that the size and the zeta potential of the synthesized nanoparticles were about 98 nm and −50 mV respectively. The nanoparticles have been used to modify the gold electrode for use as a potential electrochemical sensor for the analysis of arsenic in aqueous solution. The cyclic voltammogram recorded using gold electrode modified with AgNPs depicted a well‐defined reduction peak of arsenic compared to bare gold electrode. The enhancement of the signal is essentially due to the large surface area attributed to silver nanoparticles. Linear sweep voltammetry has been used to optimize the analytical conditions of arsenic in aqueous solution: it came out that the detection of arsenic in 0.1 M HNO3 was optimal while the electrode was conditioned at −0.6 v during 300 s. Under these optimum conditions, a calibration curve was plotted in the concentration range of 0.05 μM to 0.2 μM and the detection limit was estimated at 1.38×10−8 M, calculated from a ratio signal/noise 3.Keywords
Funding Information
- International Foundation for Science (W/5636-1)
This publication has 19 references indexed in Scilit:
- Silver nanoparticles built-in chitosan modified glassy carbon electrode for anodic stripping analysis of As(III) and its removal from waterElectrochimica Acta, 2012
- Electroanalysis of Trace Inorganic Arsenic with Gold Nanoelectrode EnsemblesElectroanalysis, 2012
- Arsenic: toxicity, oxidative stress and human diseaseJournal of Applied Toxicology, 2011
- Voltammetric methods for determination and speciation of inorganic arsenic in the environment—A reviewAnalytica Chimica Acta, 2009
- Anodic Stripping Voltammetric Detection of Arsenic(III) at Gold Nanoparticle‐Modified Glassy Carbon Electrodes Prepared by Electrodeposition in the Presence of Various AdditivesElectroanalysis, 2008
- Sensitive electrochemical detection of arsenic (III) using gold nanoparticle modified carbon nanotubes via anodic stripping voltammetryAnalytica Chimica Acta, 2008
- The Electrochemical Detection of Arsenic(III) at a Silver ElectrodeElectroanalysis, 2005
- Gold Nanoparticle Modified Electrodes Show a Reduced Interference by Cu(II) in the Detection of As(III) Using Anodic Stripping VoltammetryElectroanalysis, 2005
- Analysis and Speciation of Traces of Arsenic in Environmental, Food and Industrial Samples by Voltammetry: a ReviewElectroanalysis, 2004
- Picosecond Dynamics of Silver Nanoclusters. Photoejection of Electrons and FragmentationThe Journal of Physical Chemistry B, 1998