Effect of Jet Pulsing on Film Cooling—Part I: Effectiveness and Flow-Field Temperature Results
Authors:
- 31 May 2006
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 129 (2) , 232-246
Abstract
Pulsed film cooling was studied experimentally to determine its effect on film-cooling effectiveness. The film-cooling jets were pulsed using solenoid valves in the supply air line. Cases with a single row of cylindrical film-cooling holes inclined at 35 deg to the surface of a flat plate were considered at blowing ratios of 0.25, 0.5, 1.0, and 1.5 for a variety of pulsing frequencies and duty cycles. Temperature measurements were made using an infrared camera, thermocouples, and cold-wire anemometry. Hot-wire anemometry was used for velocity measurements. The local film-cooling effectiveness was calculated based on the measured temperatures, and the results were compared to baseline cases with continuous blowing. Phase-locked flow temperature fields were determined from cold-wire surveys. Pulsing at high frequencies helped to improve film-cooling effectiveness in some cases by reducing overall jet liftoff. At lower frequencies, pulsing tended to have the opposite effect. With the present geometry and a steady mainflow, pulsing did not provide an overall benefit. The highest overall effectiveness was achieved with continuous jets and a blowing ratio of 0.5. The present results may prove useful for understanding film-cooling behavior in engines, where mainflow unsteadiness causes film-cooling jet pulsation.Keywords
This publication has 16 references indexed in Scilit:
- Effect of Jet Pulsation and Duty Cycle on Film Cooling From a Single Jet on a Leading Edge ModelJournal of Turbomachinery, 2006
- Separation Control on Low-Pressure Turbine Airfoils Using Synthetic Vortex Generator JetsJournal of Turbomachinery, 2003
- Effects of Bulk Flow Pulsations on Film Cooling With Compound Angle Holes: Heat Transfer Coefficient Ratio and Heat Flux RatioJournal of Turbomachinery, 2001
- The Fluid Dynamics of LPT Blade Separation Control Using Pulsed JetsJournal of Turbomachinery, 2001
- Effects of Bulk Flow Pulsations on Film Cooling From Different Length Injection Holes at Different Blowing RatiosJournal of Turbomachinery, 1999
- Prediction of the Becalmed Region for LP Turbine Profile DesignJournal of Turbomachinery, 1998
- The Effect of High Free-Stream Turbulence on Film Cooling EffectivenessJournal of Turbomachinery, 1996
- Bulk flow pulsations and film cooling—I. Injectant behaviorInternational Journal of Heat and Mass Transfer, 1996
- The effect of unsteadiness on film cooling effectiveness1995
- Film Cooling With Large Density Differences Between the Mainstream and the Secondary Fluid Measured by the Heat-Mass Transfer AnalogyJournal of Heat Transfer, 1977