Dry-etch of As2S3 thin films for optical waveguide fabrication
- 24 October 2005
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 23 (6) , 1626-1632
Abstract
Plasma etching to As2S3 thin films for optical waveguide fabrication has been studied using a helicon plasma etcher. The etching effects using the processing gases or gas mixtures of O2, Ar, and CF4 were compared. It was found that the O2 plasma had no chemical etching effect to the As2S3, but it could oxidize the surface of the As2S3. The Ar plasma provided a strong ion sputtering effect to the films. The CF4 plasma exhibited a too strong chemical etch to the As2S3, leading to serious undercutting and very rough sidewalls of the waveguides. Ar and O2 gases were compared as the additives to dilute the CF4 processing gas. The etch rate of the As2S3 was reduced dramatically from over 2000nm∕min to a few hundred nm/min when the pure CF4 gas was heavily diluted with 70% Ar or O2 gas. The undercutting and sidewall roughness of the etched waveguides were also decreased greatly when above dilution was made, which was associated with an enormous weakening of the isotropic chemical etch induced by neutral reactants in the plasma. In addition, the O2 showed a better dilution effect than the Ar in reducing the etch rate of the As2S3; and the O2∕CF4 plasma also enabled a much lower erosion rate to Al mask layers than the Ar∕CF4 plasma at similar plasma conditions. The As2S3 waveguides with near vertical and very smooth sidewalls were obtained using an optimized O2∕CF4 plasma. Moreover, the etching behaviors and mechanisms were explained base on the etching results, and on the characteristics of the applied plasma diagnosed using Langmuir probe and optical spectroscopy techniques.Keywords
This publication has 21 references indexed in Scilit:
- Deposition and characterization of germanium sulphide glass planar waveguidesOptics Express, 2004
- Fabrication and characterization of low loss rib chalcogenide waveguides made by dry etchingOptics Express, 2004
- Laser-deposited As2S3 chalcogenide films for waveguide applicationsApplied Surface Science, 2002
- Strong self-phase modulation in planar chalcogenide glass waveguidesOptics Letters, 2002
- Non-linear optical properties of chalcogenide glasses in the system As–S–SeJournal of Non-Crystalline Solids, 1999
- Fabrication and characterization of integrated optical waveguides in sulfide chalcogenide glassesJournal of Lightwave Technology, 1999
- First- and second-order Bragg gratings in single-mode planar waveguides of chalcogenide glassesJournal of Lightwave Technology, 1999
- High Verdet constant Ga:S:La:O chalcogenide glasses for magneto-optical devicesOptical Engineering, 1999
- Excitation of Er3+ emission by host glass absorption in sputtered films of Er-doped Ge10As40Se25S25 glassApplied Physics Letters, 1998
- The application of the helicon source to plasma processingJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1991