Establishment and engineering application of viscoelastic-plastic constitutive laws for creep modeling in interbedded rock masses
Authors:
Open Access
- 24 November 2023
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-16
Abstract
In order to study the creep behavior of the surrounding rock of the interbedded rock mass tunnel considering the time-dependent deformation, this paper proposes a viscoelastic-plastic seven-element model considering the stress threshold, and derives and establishes its creep equation under three-dimensional stress state. At the same time, the UMAT (User-defined Material) subroutine of the model is developed based on the ABAQUS software. The rationality of the seven-element model and the effectiveness of the subprogram are verified by rheological test results. Finally, the UMAT subroutine is applied to the numerical simulation of the creep behavior of soft and hard interbedded rock tunnels with different rock inclinations (α). The results show that the different rock inclination angles have different effects on the horizontal displacement of the ground above the tunnel, settlement deformation, and the convergence of the tunnel section. With the increase of the rock inclination (0 ≤ α ≤ 90°), the horizontal displacement of the surface on both sides is antisymmetric. When α is 0°, 45° and 90°, the horizontal displacement on both sides is equivalent. Surface subsidence decreases and then increases slowly. When α is 0° and 45°, the surface subsidence is the largest (12.4 mm) and the smallest (11.1 mm), respectively. The convergence values of the tunnel section change according to different parts of the tunnel. The convergence values of the arch top and arch bottom decrease continuously, and their maximum convergence values are 23.4 mm and 17.3 mm, respectively. The change trend of the arch waist and arch shoulder convergence values is the opposite. When α is 0°, the convergence value of the arch waist is maximum (3.5 mm). When α is 15°, the convergence value of the arch shoulder is the maximum (2.0 mm).Keywords
This publication has 12 references indexed in Scilit:
- Long-term deformation and control structure of rheological tunnels based on numerical simulation and on-site monitoringEngineering Failure Analysis, 2020
- Numerical Simulation for Creep Characteristics of Soft and Hard Interphase Rock MassJournal of Physics: Conference Series, 2020
- Coupled analytical solutions for deep-buried circular lined tunnels considering tunnel face advancement and soft rock rheology effectsTunnelling and Underground Space Technology, 2019
- Elastoplastic modelling of mechanical behavior of rocks with fractional-order plastic flowInternational Journal of Mechanical Sciences, 2019
- A stability study of goaf based on mechanical properties degradation of rock caused by rheological and disturbing loadsInternational Journal of Mining Science and Technology, 2015
- Creep of phyllosilicates at the onset of plate tectonicsEarth and Planetary Science Letters, 2012
- Experimental Investigation on Triaxial Rheological Mechanical Properties of Biotite Granitic GneissApplied Mechanics and Materials, 2011
- Creep and time-dependent damage in argillaceous rocksInternational Journal of Rock Mechanics and Mining Sciences, 2006
- A tangent modulus method for rate dependent solidsComputers & Structures, 1984
- IV. On the dynamical theory of gasesPhilosophical Transactions of the Royal Society of London, 1867