Accelerator adsorption onto carbon nanotubes surface affects the vulcanization process of styrene–butadiene rubber composites
- 1 May 2009
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 113 (5) , 2851-2857
Abstract
The multiwalled carbon nanotubes (MWCNT) filled styrene–butadiene rubber (SBR) composites were prepared by incorporating MWCNT in a SBR/toluene solution and subsequently evaporating the solvent. These composites have shown a significant improvement in Young's modulus and tensile strength with respect to SBR gum without sacrificing high elongation at break. However, this improvement is less than expected at the higher filler content. Then, the influence of low concentrations of MWCNT on the vulcanization process of the SBR composites was studied by means of rheometer torque curves, swelling measurements, differential scanning calorimeter (DSC) analysis, and Fourier transform infrared (FTIR) spectroscopy. Also, their thermal degradation was studied by thermogravimetric analysis (TGA). It has been noticed that MWCNT affects the cure kinetics of SBR gum matrix reducing all parameters, i.e., the total heat rate and order of the reaction, scorch delay, maximum torque, and crosslink density. This effect increases as MWCNT content does, and it was attributed to the adsorption of the accelerator employed in the vulcanization (N‐tert‐butyl‐benzothiazole‐2‐sulfenamide) onto the MWCNT surface. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009Keywords
This publication has 34 references indexed in Scilit:
- Preparation and properties of powder styrene–butadiene rubber composites filled with carbon black and carbon nanotubesMaterials Research Bulletin, 2007
- Preparation and properties of the powder SBR composites filled with CNTs by spray drying processMaterials Letters, 2006
- Effect of multi-wall carbon nanotubes on the mechanical properties of natural rubberComposite Structures, 2006
- Natural rubber nanocomposites with SiC nanoparticles and carbon nanotubesEuropean Polymer Journal, 2006
- Polymers and carbon nanotubes—dimensionality, interactions and nanotechnologyPolymer, 2005
- Mechanical properties of carbon nanoparticle-reinforced elastomersComposites Science and Technology, 2003
- Structure and Density of Crosslinks in Natural-Rubber Vulcanizates. A Combined Analysis by NMR Spectroscopy, Mechanical Measurements, and Rubber-Elastic TheoryRubber Chemistry and Technology, 1992
- Injection Molding of Rubber Compounds: Experimentation and SimulationRubber Chemistry and Technology, 1991
- Structural Characterization of Filled Vulcanizates Part 1. Determination of the Concentration of Chemical Crosslinks in Natural Rubber Vulcanizates Containing High Abrasion Furnace BlackRubber Chemistry and Technology, 1967
- Infrared Absorption Spectra of Organic Sulfur Compounds. I. Studies on S-N Stretching Bands of Benzenesulfonamide DerivativesChemical and Pharmaceutical Bulletin, 1965