Effect of shielding rates on upward flame spread over extruded polystyrene foam in vertical channel and heat transfer mechanism
Authors:
- 28 September 2020
- journal article
- research article
- Published by Wiley in Fire and Materials
- Vol. 44 (8) , 1118-1126
Abstract
SUMMARY: Fire hazard of extruded polystyrene (XPS) thermal insulation materials has aroused public concern. In order to develop flame spread theory and the guideline for fire risk assessment of XPS, an experimental study on upward flame spread behavior and heat transfer mechanism of XPS in a vertical channel with different frontal shielding rates was conducted. Maximum temperature at the place 2 cm from XPS surface and at the center of channel first increase and then decrease as the shielding rate rises. The former is higher than the latter. Experimental value of average flame height rises as the shielding rate increases. A model for predicting the flame height is built, and the predicted results are consistent with the experimental results. Moreover, the relation between flame height and pyrolysis height under different shielding rates is obtained. The flame spread rate rises as the shielding rate increases. A prediction model of flame spread rate is established, and its prediction results are more accurate compared with those from previous models. The model also predicts that radiative heat transfer is the dominant heat transfer mode, accounting for 93% of the total heat transfer. This work is beneficial for fire risk assessment and fire safety design of building façade.Keywords
Funding Information
- China Postdoctoral Science Foundation (2016M601917, 2017T100421)
- National Natural Science Foundation of China (51974298)
- Postdoctoral Science Foundation of Jiangsu Province (1601005C)
This publication has 30 references indexed in Scilit:
- Influences of low atmospheric pressure on downward flame spread over thick PMMA slabs at different altitudesInternational Journal of Heat and Mass Transfer, 2013
- Heat transfer mechanisms in horizontal flame spread over wood and extruded polystyrene surfacesInternational Journal of Heat and Mass Transfer, 2013
- An experimental investigation on temperature profile of buoyant spill plume from under-ventilated compartment fires in a reduced pressure atmosphere at high altitudeInternational Journal of Heat and Mass Transfer, 2012
- Vertical flame spread on charring materials at different ambient temperaturesFire and Materials, 2012
- Warehouse commodity classification from fundamental principles. Part II: Flame heights and flame spreadFire Safety Journal, 2011
- Upward flame spread over corrugated cardboardCombustion and Flame, 2011
- Experimental study on the characteristics of horizontal flame spread over XPS surface on plateauJournal of Hazardous Materials, 2011
- Width effect on upward flame spreadFire Safety Journal, 2009
- Unsteady-state Upward Flame Spreading Velocity Along Vertical Combustible Solid And Influence Of External Radiation On The Flame SpreadFire Safety Science, 1991
- The Dependence of Flame Propagation on Surface Heat Transfer II. Upward BurningCombustion Science and Technology, 1977