Distribution of higher‐order structures in injection moldings of particulate‐filled polypropylenes
Authors:
- 5 July 1991
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 43 (1) , 97-128
Abstract
Flexural test specimens were injection‐molded from polypropylenes filled with flaky talc or spherical calcium carbonate at levels of 0‐40 wt % under cylinder temperatures of 200‐320°C. Distributions in the flow direction of higher‐order structures such as thickness of skin layer, a*‐axis‐oriented component fraction [A*], and crystalline orientation functions and distributions in the thickness direction of higher‐order structures such as crystallinity, β‐crystal content, [A*], and crystalline orientation functions were studied. These higher‐order structures are inhomogeneous in the flow and thickness directions also for injection moldings of particulate‐filled polypropylenes, which strongly influences the product properties such as mechanical and thermal properties. Molecular orientation process in injection molding was theoretically analyzed from a viewpoint of growth of recoverable shear strain at the gate and its relaxation in the cavity, which could considerably well explain the influences of particulate filling and cylinder temperature on not only the mean values but also the changes in the flow and thickness directions, of the quantities such as thickness of the skin layer and crystalline orientation functions, which express the degree of molecular orientation.Keywords
This publication has 45 references indexed in Scilit:
- Conductive PE-carbon black composites by elongational flow injection mouldingJournal of Materials Science, 1988
- The Effect of Fountain Flow on Molecular Orientation in Injection MoldingJournal of Rheology, 1988
- Conductive PE-carbon composites by elongation flow injection mouldingJournal of Materials Science, 1988
- Bildung orientierter Randschichten in Spritzgußplatten aus PolypropylenRheologica Acta, 1987
- A structure‐oriented computer simulation of the injection molding of viscoelastic crystalline polymers part II: Model predictions and experimental resultsPolymer Engineering & Science, 1986
- A structure‐oriented computer simulation of the injection molding of viscoelastic crystalline polymers part I: Model with fountain flow, packing, solidificationPolymer Engineering & Science, 1986
- Influence of glass fiber content on the morphology and mechanical properties in injection molded polypropylene compositesPolymer Composites, 1985
- Dynamic and transient rheological properties of glass filled polymer meltsRheologica Acta, 1985
- Effect of molecular parameters on the shrinkage of injection-molded polypropyleneJournal of Applied Polymer Science, 1978
- Thermal conductivity of polymer meltsJournal of Applied Polymer Science, 1971