Additive manufacturing of complexly shaped SiC with high density via extrusion-based technique – Effects of slurry thixotropic behavior and 3D printing parameters
Authors:
- Ruoyu ChenRCRuoyu Chen
- Adam BrattenABAdam Bratten
- Joshua RittenhouseJRJoshua Rittenhouse
- Tian HuangTHTian Huang
- Wenbao JiaWJWenbao Jia
- Ming C. LeuMLMing C. Leu
- Haiming WenHWHaiming Wen
- 17 June 2022
- journal article
- research article
- Published by Elsevier in Ceramics International
- Vol. 48 (19) , 28444-28454
Abstract
No abstract availableKeywords
Funding Information
- Office of Nuclear Energy
- U.S. Nuclear Regulatory Commission (NRC 31310018M0044)
This publication has 33 references indexed in Scilit:
- Grey system theory-based models in time series predictionExpert Systems with Applications, 2010
- ThixotropyAdvances in Colloid and Interface Science, 2009
- SiC Foams Produced by Gel Casting: Synthesis and CharacterizationAdvanced Engineering Materials, 2004
- High temperature sintering of SiC with oxide additives: IV. Powder beds and the influence of vaporization on the behaviour of SiC compactsJournal of the European Ceramic Society, 2003
- Preparation of SiC/SiC Composites by Hot Pressing, Using Tyranno‐SA Fiber as ReinforcementJournal of the American Ceramic Society, 2003
- Colloidal Inks for Directed Assembly of 3-D Periodic StructuresLangmuir, 2002
- An investigation of machine learning based prediction systemsJournal of Systems and Software, 2000
- Densification behavior and mechanical properties of pressureless-sintered silicon carbide ceramics with alumina and yttria additionsMaterials Chemistry and Physics, 1999
- Effect of Weight Loss on Liquid‐Phase‐Sintered Silicon CarbideJournal of the American Ceramic Society, 1997
- Theory of mechanochemical systemsJournal of Polymer Science, 1954