Typical bearing-fault rating using force measurements: application to real data
Authors:
- 13 April 2011
- journal article
- research article
- Published by SAGE Publications in Journal of Vibration and Control
- Vol. 17 (14) , 2164-2174
Abstract
In contrast to the commonly used acceleration measurement, this research discusses the use of force measurements to identify bearing faults. A force sensor is fixed between the rigid surroundings and the bearing to measure all of the reactive forces due to the vibration excitation. Using a force measurement, systematically prepared samples with the five typical faults that can occur during the assembly process (axial, radial, bending moment, contamination and shield defect) were investigated. The samples were prepared with low, medium and high fault ratings. The force measurement, with its relatively simple signal processing based on an envelope detection, was shown to be successful in correctly identifying both the fault rating and the fault type. The presented approach was successfully applied to high-series assembly production and is relatively easy to apply to similar applications.Keywords
This publication has 21 references indexed in Scilit:
- Rolling element bearing faults diagnosis based on optimal Morlet wavelet filter and autocorrelation enhancementMechanical Systems and Signal Processing, 2010
- Automated diagnosis of rolling bearings using MRA and neural networksMechanical Systems and Signal Processing, 2010
- Rolling Bearing Fault Classification Based on Envelope Spectrum and Support Vector MachineJournal of Vibration and Control, 2009
- Fault classification of rolling bearing based on reconstructed phase space and Gaussian mixture modelJournal of Sound and Vibration, 2009
- Rolling element bearings multi-fault classification based on the wavelet denoising and support vector machineMechanical Systems and Signal Processing, 2007
- An analysis method for the vibration signal with amplitude modulation in a bearing systemJournal of Sound and Vibration, 2007
- A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearingsTribology International, 1999
- On initial fault detection of a tapered roller bearing: Frequency domain analysisJournal of Sound and Vibration, 1992
- The vibration produced by multiple point defects in a rolling element bearingJournal of Sound and Vibration, 1985
- Model for the vibration produced by a single point defect in a rolling element bearingJournal of Sound and Vibration, 1984