In-Cylinder Measurements of Soot Production in a Direct-Injection Diesel Engine
Authors:
- 1 February 1988
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In-cylinder and exhaust soot mass measurements have been made on a single-cylinder conversion of a 4-cylinder, 2.8 1, high-swirl, direct-injection diesel engine using a sampling system which allows dumping, diluting, quenching, and collecting the entire contents of the cylinder on a time scale o£ about 1 ms. Experiments have been performed at engine speeds of 1,000 and 1,500, and equivalence ratios, ϕ, of 0.4 and 0.7. Soot mass first appears shortly after top dead center and reaches a peak between 15 and 30 crankangle degrees after top dead center (CAD ATDC). After reaching its peak value, soot concentration decreases with increasing crankangle and approaches exhaust levels by 40-60 CAD ATDC. The time lag between the start of combustion and the first appearance of soot increases with ϕ and ranges from 0.2 to 1 ms. The initial rate of soot formation ranges from 0.26 to 0.30 mg ms−1 and varies little with speed or ϕ. The peak in-cylinder soot concentration only increases slightly (less than 20%) with ϕ. On the other hand, at ϕ = 0.4, oxidation reduces the exhaust soot concentration to roughly 15% of the peak in-cylinder value, while at ϕ = 0.7, oxidation is much less effective and the exhaust soot concentration is 60–80% of the peak value. It appears that oxygen availability late in the cycle is a critical factor in determining exhaust soot concentrations of this engine.Keywords
This publication has 22 references indexed in Scilit:
- Particle Concentrations in a Diesel Cylinder: Comparison of Theory and ExperimentSAE International Journal of Advances and Current Practices in Mobility, 1986
- In-Cylinder Measurements of Particulate Formation in an Indirect Injection Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1986
- The Influence of a Ceramic Particle Trap on the Size Distribution of Diesel ParticlesSAE International Journal of Advances and Current Practices in Mobility, 1985
- In-cylinder NOx histories in an indirect injection diesel engine: Comparison between experimental data and model predictionsSymposium (International) on Combustion, 1985
- Measurements of Polycyclic Aromatic Compounds in the Cylinder of an Operating Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1984
- In-Cylinder Measurement of Particulate Number Density and SizeSAE International Journal of Advances and Current Practices in Mobility, 1982
- Total Cylinder Sampling from a Diesel Engine (Part II)SAE International Journal of Advances and Current Practices in Mobility, 1982
- Measurement of Flame Temperature Distribution in a D.I. Diesel Engine by Means of Image Analysis of Nega-Color PhotographsSAE International Journal of Advances and Current Practices in Mobility, 1981
- Total Cylinder Sampling from a Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1981
- Diesel Exhaust Particle Size Distribution Measurement TechniquesSAE International Journal of Advances and Current Practices in Mobility, 1980