Suitable Material Selection for Large Size Cylindrical Gears*
Authors:
- 1 February 2021
- journal article
- research article
- Published by Walter de Gruyter GmbH in HTM Journal of Heat Treatment and Materials
- Vol. 76 (1) , 19-35
Abstract
Globalization and international supply chains constantly challenge gear- and steel manufacturers. In the case of large gear units in particular, expensive alloy contents have a direct impact on the material price. Steels with lower alloy contents and therefore cheaper steels are therefore becoming the focus of attention in order to further improve competitiveness. This article therefore compares two materials with different alloying elements and contents and thus different hardenability behaviour. For this purpose, extensive material characterizations as well as pulsator tests were carried out on case-hardened large gears. The aim of these tests was to determine the tooth root load-bearing capacity of the two material variants. Finally, the results are compared, discussed and recommendations for industrial application are derived, taking into account the hardenability of large gears. ◼Keywords
This publication has 6 references indexed in Scilit:
- Optimizing Gear Performance by Alloy Modification of Carburizing SteelsMetals, 2017
- Tooth Flank Breakage: Influences on Subsurface Initiated Fatigue Failures of Case Hardened Gears2013
- Zahnradgetriebe — Grundlagen (Stirnräder)2003
- Effect of Case Depth on Fatigue Strength of Case-hardened GearBulletin of JSME, 1986
- Einfluß von Einsatzhärtungstiefe und Kernhärte auf die Biegedauerfestigkeit von aufgekohlten ZahnrädernHTM Journal of Heat Treatment and Materials, 1970
- Case Crushing of Carburized and Hardened GearsSAE International Journal of Advances and Current Practices in Mobility, 1961