The Geometric Surface Structure of EN X153CrMoV12 Tool Steel after Finish Turning Using PCBN Cutting Tools
Open Access
Abstract
The article presents the results of studying the effects of coated (TiN, TiAlN) and uncoated polycrystalline cubic boron nitride (PCBN) machining blades on the key geometric structure parameters of the surface of hardened and tempered EN X153CrMoV12 steel after finish turning. A comparative analysis of the use of coated and coated cutting tools in finish turning of hardened steels was made. Tool materials based on polycrystalline cubic boron nitride PCBN (High-CBN; Low-CBN) have been described and characterized. The advantages of using TiN and TiAlN-coated cutting tools compared to uncoated were demonstrated. The lowest influence of the feed on the values of all tested roughness parameters was noted for surfaces treated with TiN- and TiAlN-coated tools (both with 50 vol.% of CBN). For uncoated tools (60 vol.% of CBN) for feeds f = 0.2 and 0.3 mm/rev., the highest values of Ra and Rz roughness parameters were found. Moreover, the lack of protective coating contributed to the occurrence of intense adhesive wear on the flank surface, which was also in the range of the feed values f = 0.2 and 0.3 mm/rev. The analysis of material surface after treatment with the uncoated tools with the feed f = 0.2 mm/rev. showed the occurrence of the phenomenon of lateral material flow and numerous chip deflections.Keywords
This publication has 32 references indexed in Scilit:
- Scratch adhesion characteristics of PVD TiAlN deposited on high speed steel, cemented carbide and PCBN substratesWear, 2013
- Wear mechanisms of PVD-coated PCBN cutting toolsWear, 2013
- Evolution of Surface Roughness in Grinding and its Relationship with the Dressing Parameters and the Radial WearProcedia Engineering, 2013
- Cutting force analysis in reaming of ZL102 aluminium cast alloys by PCD reamerThe International Journal of Advanced Manufacturing Technology, 2012
- Turning of interrupted and continuous hardened steel surfaces using ceramic and CBN cutting toolsJournal of Materials Processing Technology, 2011
- Investigation of TiN Coated CBN and CBN Cutting Tool Performance in Hard Milling ApplicationStrojniški vestnik - Journal of Mechanical Engineering, 2011
- Multicriteria optimization of hard turning operation of the hardened 18HGT steelThe International Journal of Advanced Manufacturing Technology, 2009
- Tool wear when turning hardened AISI 4340 with coated PCBN tools using finishing cutting conditionsInternational Journal of Machine Tools and Manufacture, 2007
- Hard turning of tempered DIN 100Cr6 steel with coated and no coated CBN insertsJournal of Materials Processing Technology, 2006
- The influence of the microstructure of hardened tool steel workpiece on the wear of PCBN cutting toolsInternational Journal of Machine Tools and Manufacture, 2003