Influence of Surface Mechanical Attrition Treatment on Fretting Wear Behaviour of Ti-6Al-4V
- 10 February 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 463-464, 316-320
Abstract
Ti-6Al-4V alloy was subjected to surface mechanical attrition treatment (SMAT) by using SAE 52100 steel balls of 5 mm diameter for two treatment durations (30 and 60 min). SMAT resulted in the formation of nanostructured material on the surface and near surface regions, increased hardness, increased surface roughness and compressive residual stress on the surface. Treated samples exhibited lower tangential force coefficient (TFC) compared to untreated samples. Samples treated for 60 min exhibited higher grain refinement, higher hardness, lower surface roughness and higher TFC compared to the samples treated for 30 min. Fretting wear resistance of the samples treated for 30 min was higher than that of untreated samples and the samples treated for 60 min. Due to very high hardness and presumably reduced ductility, the fretting wear resistance of the samples treated for 60 min was lower than that of the untreated samples and samples treated for 30 min.Keywords
This publication has 12 references indexed in Scilit:
- Effect of surface nanocrystallization on the corrosion behaviour of AISI 409 stainless steelCorrosion Science, 2010
- Fretting wear behavior of nanocrystalline surface layer of copper under dry conditionWear, 2008
- Plastic strain-induced grain refinement at the nanometer scale in copperActa Materialia, 2006
- Development of a fretting wear test rig and preliminary studies for understanding the fretting wear properties of steelsMaterials & Design (1980-2015), 2006
- Nanostructured surface layer on metallic materials induced by surface mechanical attrition treatmentMaterials Science and Engineering: A, 2004
- Effect of grain size on the tribological behavior of nanocrystalline nickelMaterials Science and Engineering: A, 2004
- Mechanical behavior of nanocrystalline metals and alloys11The Golden Jubilee Issue—Selected topics in Materials Science and Engineering: Past, Present and Future, edited by S. SureshActa Materialia, 2003
- Formation of nanostructured surface layer on AISI 304 stainless steel by means of surface mechanical attrition treatmentActa Materialia, 2003
- Use of equations for wear volume determination in fretting experimentsWear, 2000
- Electrochemical studies of fretting corrosionWear, 1968